Sharp MX-GB50A (serv.man4) Service Manual ▷ View online
Sharp SmartPunch Pro Installation Manual
1
Sharp SmartPunch
™
Pro
Installation Manual
Sharp SmartPunch Pro Installation Manual
2
Contents
Page
1.
Recommendations and Pre-requisites
3
2.
Unpacking
3
3.
Cable Connections
3
4.
Installing the Sound Deadening Foam
6
5.
Docking Bracket Installation
8
6.
Leveling & Height Adjustment
9
7.
Final Steps
10
ACCO Brands
300 Tower Parkway
Lincolnshire, IL 60069-3640
www.acco.com
300 Tower Parkway
Lincolnshire, IL 60069-3640
www.acco.com
Sharp SmartPunch Pro Installation Manual
3
1 Recommendations and Pre-requisites
•
You will need the installation kit provided with the SmartPunch Pro unit, which can be found in the
main carton.
main carton.
2 Unpacking
•
Inspect the outside of the package for shipping damage. If there is evidence of shipping damage,
contact the shipping carrier immediately.
contact the shipping carrier immediately.
•
Remove the punch from its shipping carton. Three people are recommended, one lifting at the
casters while two lift at the top cover. DO NOT lift using the front door panel.
casters while two lift at the top cover. DO NOT lift using the front door panel.
•
Retain the smaller accessory box; it contains parts required for correct installation of the
SmartPunch Pro.
SmartPunch Pro.
•
Inspect for any concealed damage to the unit. If there is evidence of concealed shipping damage,
contact the shipping carrier immediately.
contact the shipping carrier immediately.
•
Remove all shipping tape from doors and levers.
3 Cable Connections and Paper guides
Review the table below to identify which section of the guide to refer to install the SmartPunch Pro
Section
Device upstream to SmartPunch Pro
3.1
MX-CF11 Inserter (or) MX-ST10 High Capacity Stacker
3.2
MX-RB18 Curl correction unit
3.1
Cable connections
a) Remove the finisher rear cover and plug the 7 pin communication cable to CN145 on the
finisher board. The communication cable is provided in the Installation kit of SmartPunch Pro.
(Finisher to SmartPunch Pro cable P/N OPT7712585)
GBC will update
this with a new
picture showing
IF bracket
this with a new
picture showing
IF bracket
Sharp SmartPunch Pro Installation Manual
4
b) Plug the free end of the cable from step a) into the right side of the SmartPunch Pro.
c) There are two entrance paper guides provided with the SmartPunch Pro. Use the longer paper
guide measuring about 31mm (in paper flow direction) when used in conjunction with Inserter MX-
CF11 or High Capacity Stacker MX-ST10. Install the paper guide, using the size #8 screws
provided, to the lower entrance guide of the SmartPunch Pro.
Go to Section 4 to complete the installation.
3.2
Cable connections
Follow the same steps as in 3.1 a, b.
d) There are two entrance paper guides provided
with the SmartPunch Pro. Use the shorther
paper guide measuring about 24mm (in paper
flow direction) when used in conjunction with
Curl correction unit MX-RB18. Install the paper
guide, using the size #8 screws provided, to the
lower entrance guide of the SmartPunch Pro.
Go to Section 4 to complete the installation.
GBC will update this picture to
show the new Entrance guides
for SmartPunch Pro
show the new Entrance guides
for SmartPunch Pro
GBC will update this picture to
show the new Entrance guides
for SmartPunch Pro
show the new Entrance guides
for SmartPunch Pro