Sharp MX-FNX5 (serv.man7) Service Manual / Technical Bulletin ▷ View online
Sharp Electronics (UK) Ltd., Technical Services Group
1. Model Name:
MX-FNX5 (Options for MX-M850/M950/M1100)
2. General:
When using paper that creates a large amount of paper dust, to increase the
amount of paper dust that a staple gear can handle, used in combination with the
stapler of the MX-FNX5 (finisher), after about 200k to 300k staples the staple gear
can deteriorate causing an "F1-10" error (stapler motor trouble).
stapler of the MX-FNX5 (finisher), after about 200k to 300k staples the staple gear
can deteriorate causing an "F1-10" error (stapler motor trouble).
Due to this deterioration, a staple gear has been prepared as a new individual
service part.
service part.
For replacement instructions please refer to the attached sheets.
3. Parts Action:
Ref.
No.
Model
name
Version P/G No.
Current parts
New parts
Price
rank
Q'ty Parts
name
Effective
time
Inter-
change
-
ability
Parts code
Parts code
1 MX-FNX5 ALL 15-
--- 0PPC3089111//
AS
1
STAPLER
GEAR
---
---
<Interchange>
1. Interchangeable.
4. Not interchangeable.
2. Current type can be used in place of new type.
New type cannot be used in place of current type.
5. Interchangeable if replaced with same types of
related parts in use.
3. Current type cannot be used in place of new type.
New type can be used in place of current type.
6. Others.
Parts marked with "
" is important for maintaining the safety of the set. Be sure to replace these parts with
specified ones for maintaining the safety and performance of the set.
NEW STAPLER SERVICE PART
TECHNICAL BULLETIN
Date:
16
th
August 2010
Model:
FNX5
Ref.:
09
Colour:
White
Page:
1 of 4
Sharp Electronics (UK) Ltd., Technical Services Group
MX-FNX5 - Instructions for Replacing the Staple Gear
* Remove the stapler unit from the finisher. For instructions on mounting, refer to the MX-FNX5
Service Manual.
(1) Remove 1 E ring and 2 screws, and then remove the coupling plate unit.
(Screw x2, E ring x1)
(Screw x2, E ring x1)
(2) Remove the gear plate from the drive shaft.
(3) Remove the stapler gear from the drive shaft.
Sharp Electronics (UK) Ltd., Technical Services Group
(4) Apply grease (UKOG-0307FCZZ: furoyl G-313S) to the inner and outer wall around the entire
circumference of the cam groove of the new staple gear.
(5) Mount the staple gear while keeping the cam groove of the staple gear aligned to the arm
ring roller.
ring roller.
(6) Align the gear plate to the protrusion of the staple gear, and then mount the gear plate to
the staple gear.
Sharp Electronics (UK) Ltd., Technical Services Group
(7) Apply grease (UKOG-0307FCZZ: furoyl G-313S) to the drive shaft hole on the coupling plate
unit.
(8) Mount the coupling plate with 2 screws and 1 E ring.(Screw x2, E ring x1)
Display
