Sharp MX-FN19 / MX-FN20 / MX-PN12 (serv.man5) Service Manual ▷ View online
MX-7040N MX-FN19 (FINISHER (50 sheets binding)) 13 – 4
D. Check of the connected position of main unit
and finisher
1)
Insert the rail of the finisher into the slit on the rail reception
sheet metal of the main unit, install the finisher.
sheet metal of the main unit, install the finisher.
2)
Remove the screw, and remove the connector cover on rear
side of the finisher.
side of the finisher.
3)
Check that the center of the screw hole of the finisher is in the
range of specification of an oval hole of the connection fixture
that exist on main body rear side.
range of specification of an oval hole of the connection fixture
that exist on main body rear side.
* When not the range of specification, progress to the proce-
dure of "E. Adjustment".
If the adjustment is not required, remove the screws from
the screw hole directly and push the caster into it until the
installation fixing.
If the adjustment is not required, remove the screws from
the screw hole directly and push the caster into it until the
installation fixing.
E. Adjustment
1)
Remove the finisher from the main unit.
2)
Remove the screw, slide to the left the front lower cover, and
remove it.
remove it.
MX-7040N MX-FN19 (FINISHER (50 sheets binding)) 13 – 5
3)
Open the front upper cover.
4)
Remove the front upper cover.
5)
Remove the screws, and open the front lower cover.
6)
Remove the fixing tapes.
7)
Remove the screws, and remove the auxiliary wheels.
8)
Remove the screws, and remeve the rear lower cover.
9)
Remove the fixing tapes.
2
1
1
MX-7040N MX-FN19 (FINISHER (50 sheets binding)) 13 – 6
10) Loosen both of the caster fixing screws of the front side and
rear side.
11) Remove the screw, and remove the spanner installed inside
the front lower door.
12) Turn the bolt for which the adjustment is necessary, and adjust
to become it within the range of specification.
13) Check to insure that the upper and lower clearances between
the main unit and the finisher are even.
MX-7040N MX-FN19 (FINISHER (50 sheets binding)) 13 – 7
14) Tighten the caster fixing screws so that the indicator scale is
fit.
15) Install the rear lower cover with the fixing screws.
16) Install the auxiliary wheels with the fixing screws.
17) Install the spanner for adjustment to inside the front lower door.
18) Close the front lower cover, and secure it with the fixing
screws.
19) Attach the front upper cover.
20) Close the front upper cover.
1
2
2