Sharp MX-CF11 / MX-6240N / MX-7040N (serv.man2) Service Manual ▷ View online
MX-7040N Dehumidifying heater kit 3 – 13
(4) Paper feed unit attachment
1)
Attach the paper feed unit, and fix by the screw. Connect the
connector.
connector.
2)
Attach the torque limiter unit, and fix by the screw.
3)
Attach the upper cabinet, and fix by the screw.
4)
Attach the left rear cabinet, and fix by the screw.
5)
Attach the sheet, and fix by the screw. Close the upper cover.
6)
Insert the paper feed tray.
(5) Connector connection
1)
Remove the screw, and remove the connector cover.
2)
Connect the connector, and tighten the screw.
MX-7040N Dehumidifying heater kit 3 – 14
J. Installation of the LCC (A3) heater kit
(1) Paper feed unit removal
1)
Pull out the paper feed tray.
2)
Remove the screw, and remove the left front cabinet.
3)
Open the upper cover, and remove the screw.
4)
Remove the upper cabinet.
5)
Disconnect the connector. Remove the screw, and remove the
paper feed unit.
paper feed unit.
(2) Cover removal
1)
Remove the screw, and remove the cover.
(3) Heater attachment
1)
Attach the heater, and fix by the screw. Attach the connector to
the frame, and fix the snap band.
the frame, and fix the snap band.
(4) Heater harness unit attachment
1)
Attach the snap band of the heater harness unit, and fix by the
screw. While holding the harness upward, attach the AC cord
fixer.
screw. While holding the harness upward, attach the AC cord
fixer.
NOTE: After attaching the snap band, cut and trim the end of
the band.
NOTE: Be careful not to mistake the attaching direction of the
AC cord fixer.
2
1
1
2
MX-7040N Dehumidifying heater kit 3 – 15
2)
Pull the harness tightly in the arrow direction, and check to
confirm that there is no disconnection of the snap band and
that the square hole in the frame is not covered with the har-
ness.
confirm that there is no disconnection of the snap band and
that the square hole in the frame is not covered with the har-
ness.
3)
Connect the connector of the heater harness unit. Attach the
earth wire, and fix by the screw.
earth wire, and fix by the screw.
NOTE: Attach the earth wire at an angle of 45 degrees.
(5) Heater cover and heater sheet attachment
1)
Attach the heater cover with the screws (M4 x 8).
2)
Attach the heater sheet.
For the reference, see below.
NOTE: Attach the sheet so that it does not extend out from the
X and Y lines.
45q
Top view
X
Y
MX-7040N Dehumidifying heater kit 3 – 16
(6) Cover attachment
1)
Attach the cover, and fix the screw.
(7) Paper feed unit attachment
1)
Attach the paper feed unit, and fix by the screw. Connect the
connector.
connector.
2)
Attach the upper cabinet.
3)
Fix the screw, and close the upper cover.
4)
Attach the left front cabinet, and fix by the screw.
5)
Insert the paper feed tray.
(8) Connector connection
1)
Remove the screw, and remove the connector cover.
2)
Connect the connector, and tighten the screw.
Click on the first or last page to see other MX-CF11 / MX-6240N / MX-7040N (serv.man2) service manuals if exist.