Sharp MX-BMX1 (serv.man2) Service Manual ▷ View online
TR-3-2
20 October 2010
3.1.2 TOP COVER
COVERS
[A]
[B]
[B]
Removal
1. Pry off the Gas spring [A] using a screw driver.
2. Remove screws and nuts [B] ( x4, x4).
Replacement
1. Reverse the removal procedure.
Adjustment
1. Loosen screws and nuts [B] ( x4, x4).
2. Adjust Top cover so frame edge [C] is aligned with top of the hinge [D].
1. Pry off the Gas spring [A] using a screw driver.
2. Remove screws and nuts [B] ( x4, x4).
Replacement
1. Reverse the removal procedure.
Adjustment
1. Loosen screws and nuts [B] ( x4, x4).
2. Adjust Top cover so frame edge [C] is aligned with top of the hinge [D].
See drawings above.
3. Tighten screws and nuts [C] ( x4, x4).
Bad
Top cover too low
Bad
Top cover too high
Good
[D]
[C]
Replacement Adjustment
20 October 2010
TR-3-3
3.1.3 BLOWER MOTOR M5 / M6
COVERS
Removal
1. Open the Top Cover.
2. Cut tie-wrap [A]
2. Disconnect connectors [B] (
1. Open the Top Cover.
2. Cut tie-wrap [A]
2. Disconnect connectors [B] (
x2).
3. Remove Front and Rear cover (
3.1.1).
4. Remove Infeed cover (
3.1.4).
5. Remove screws [C] ( x2).
6. Lift out Fan assy
6. Lift out Fan assy
Replacement
1. Reverse the removal procedure.
1. Reverse the removal procedure.
[B]
[A]
[C]
TR-3-4
20 October 2010
3.1.4 INFEED COVER
COVERS
1. Open the Top Cover.
2. Remove Front and Rear cover (
2. Remove Front and Rear cover (
3.1.1).
3. Remove screws [A] ( x5).
4. Remove screws [B] ( x5).
4. Remove screws [B] ( x5).
[A]
[B]
Replacement Adjustment
20 October 2010
TR-3-5
3.1.5 LOCKING BRACKET
COVERS
[A]
[B]
Removal
1. Loosen nuts [A] ( x2).
2. Locking bracket will fall down.
Replacement
1. Push Trimmer against Bookletmaker.
2. Push up Locking bracket so it latches studs [B].
3. Tighten nuts [A] ( x2).
[B]
Click on the first or last page to see other MX-BMX1 (serv.man2) service manuals if exist.