Sharp MX-5500N / MX-6200N / MX-7000N (serv.man29) Peripheral ▷ View online
MX-7000N MX-FNX4 8 – 5
3)
Check that the center of the screw hole of the finisher is in the
range of specification of an oval hole of the connection fixture
that exist on main body rear side.
range of specification of an oval hole of the connection fixture
that exist on main body rear side.
* When not the range of specification, execute the following
adjustment. If the adjustment is not required, Progress to the
procedure of "E. Touch of the auxiliary caster with the floor".
procedure of "E. Touch of the auxiliary caster with the floor".
D. Adjustment
1)
Remove the finisher from the main unit.
2)
Open the front door.
3)
Remove the cabinet fixing screw.
4)
Remove the screw, and remove the front lower cabinet 1.
Remove the fixing screw of the front lower cabinet 2.
Remove the fixing screw of the front lower cabinet 2.
5)
Remove the screws, and slide to the left the front lower cabinet
2, and remove it.
2, and remove it.
6)
Remove the fixing tapes.
MX-7000N MX-FNX4 8 – 6
7)
Remove the screws, and remove the rear lower cover.
8)
Remove the fixing tapes.
9)
Loosen the caster fixing screws.
10) Remove the screw, and remove the spanner installed inside
the front door.
11) Turn the bolt for which the adjustment is necessary, and adjust
to become it within the range of specification.
12) Check to insure that the upper and lower clearances between
the main unit and the finisher are even.
MX-7000N MX-FNX4 8 – 7
13) Tighten the caster fixing screws so that the indicator scale is
fit.
14) Install the rear lower cover with the fixing screws.
15) Install the front lower cabinet 2 with the fixing screws.
16) Install the front lower cabinet 1 with the fixing screws.
17) Attach the cabinet fixing screw.
18) Install the spanner for adjustment to inside the front door with
screw.
19) Close the front door.
MX-7000N MX-FNX4 8 – 8
E. Connection of the saddle stitch finisher
1)
Engage the saddle stitch finisher to the main unit.
2)
Open the front door of saddle stitch finisher.
3)
Fix the saddle stitch finisher to the main unit with the step
screw B (Package part No. 4).
screw B (Package part No. 4).
4)
Close the front cover.
5)
Remove the screw, and remove the connector cover on rear
side of the finisher.
side of the finisher.
6)
Install the Step screw B (Package part No. 4).
7)
Attach the connector cover on rear side of the finisher with the
fixing screw.
fixing screw.
Click on the first or last page to see other MX-5500N / MX-6200N / MX-7000N (serv.man29) service manuals if exist.