DOWNLOAD Sharp MX-5500N / MX-6200N / MX-7000N (serv.man29) Service Manual ↓ Size: 3.08 MB | Pages: 9 in PDF or view online for FREE

MX-7000N  MX-FNX4  8 – 4

<Note before installation>
* When the MX-FNX4 is installed, first install the MX-RBX2, and

then install the MX-FNX4.

* When the MX-FNX4 and MX-PNX2 is installed at the same time,

first install the MX-PNX2, and then install the MX-FNX4.

* When the MX-FNX4 and MX-CFX1 is installed at the same time,

execute the installation procedure of MX-CFX1.

1)

Install the rail (Package part No. 5) to the saddle stitch finisher
with the fixing screws (Package part No. 1).

2)

Install the rail reception sheet metal (Package part No. 6) to
the main unit with the fixing screws (Package part No. 3).

1)

Install the connection fixture R (Package part No. 8) to the
main unit with the fixing screws (Package part No. 3).

2)

Install the connection fixture F (Package part No. 7) to the
main unit with the fixing screws (Package part No. 3).

1)

Insert the rail of the finisher into the slit on the rail reception
sheet metal of the main unit, install the finisher.

2)

Remove the screw, and remove the connector cover on rear
side of the finisher.

MX-7000N  MX-FNX4  8 – 5

3)

Check that the center of the screw hole of the finisher is in the
range of specification of an oval hole of the connection fixture
that exist on main body rear side.

* When not the range of specification, execute the following

adjustment. If the adjustment is not required, Progress to the
procedure of "E. Touch of the auxiliary caster with the floor".

1)

Remove the finisher from the main unit.

2)

Open the front door.

3)

Remove the cabinet fixing screw.

4)

Remove the screw, and remove the front lower cabinet 1.
Remove the fixing screw of the front lower cabinet 2.

5)

Remove the screws, and slide to the left the front lower cabinet
2, and remove it.

6)

Remove the fixing tapes.

MX-7000N  MX-FNX4  8 – 6

7)

Remove the screws, and remove the rear lower cover.

8)

Remove the fixing tapes.

9)

Loosen the caster fixing screws.

10) Remove the screw, and remove the spanner installed inside

the front door.

11) Turn the bolt for which the adjustment is necessary, and adjust

to become it within the range of specification.

12) Check to insure that the upper and lower clearances between

the main unit and the finisher are even.

MX-7000N  MX-FNX4  8 – 7

13) Tighten the caster fixing screws so that the indicator scale is

fit.

14) Install the rear lower cover with the fixing screws.

15) Install the front lower cabinet 2 with the fixing screws.

16) Install the front lower cabinet 1 with the fixing screws.

17) Attach the cabinet fixing screw.

18) Install the spanner for adjustment to inside the front door with

screw.

19) Close the front door.