DOWNLOAD Sharp MX-5500N / MX-6200N / MX-7000N (serv.man207) Service Manual ↓ Size: 244.94 KB | Pages: 5 in PDF or view online for FREE

Model
MX-5500N MX-6200N MX-7000N (serv.man207)
Pages
5 Few pages! See other manuals at the bottom of the first or last page.
Size
244.94 KB
Type
PDF
Document
Service Manual / Technical Bulletin
Brand
Device
Copying Equipment / SCANNER DRYING HEATER AS SERVICE PART
File
mx-5500n-mx-6200n-mx-7000n-sm207.pdf
Date

Sharp MX-5500N / MX-6200N / MX-7000N (serv.man207) Service Manual / Technical Bulletin ▷ View online

3/5
4. Mount five clamps.
*For the clamp mounting locations and direction, see the figure below.
*Take care not to damage the wire when mounting clamps.
5. Remove the two screws from the bottom of the scanner (see the figure below). (Do not use two M3x4S tight
screws and the removed screws.)
4/5
6.Connect the connector of the heater fixing plate assy (explained on Page 1) to the heater (see the figure
below) and secure it with two M3x4 round-tipped screws.(Tight two screws)
*Screw tightening torque: 1.0 to 1.2 N m
*Secure the connector securely (see the figure below).
*Insert the positioning dowel into the hole.
7. Secure the heater with the M4x6 bind machine screw.
*Screw tightening torque: 1.6 to 1.8 N m
*The heater pawl must be inserted into the hole.
8. Pass the heater harness through the five clamps and perform wire processing.
5/5
9. Secure the heater wire with a snap band.
*Secure the heater wire with the snap band while pulling it in the arrow direction. (The lower part of the wire
must be free from loose.)
*Cut the snap band tip approx. 5 mm or less.
10. Move the lamp UN by hand and check that all the movable parts move smoothly.
*Check that there is no interference in the lower parts of the heater harness, wire, and 2/3 mirror UN.
*Check that each part is free from interference.
11. Remount the removed parts by reversing the procedure.
5/5
9. Secure the heater wire with a snap band.
*Secure the heater wire with the snap band while pulling it in the arrow direction. (The lower part of the wire
must be free from loose.)
*Cut the snap band tip approx. 5 mm or less.
10. Move the lamp UN by hand and check that all the movable parts move smoothly.
*Check that there is no interference in the lower parts of the heater harness, wire, and 2/3 mirror UN.
*Check that each part is free from interference.
11. Remount the removed parts by reversing the procedure.
Page of 5
Display

Sharp MX-5500N / MX-6200N / MX-7000N (serv.man207) Service Manual / Technical Bulletin ▷ Download