Sharp MX-5500N / MX-6200N / MX-7000N (serv.man10) Peripheral ▷ View online
MX-LCX2 DISASSEMBLY AND ASSEMBLY 6 – 1
MX-LCX2
Service Manual
[6] DISASSEMBLY AND
ASSEMBLY
1. Maintenance parts replacement
procedures
A. Paper feed roller
1) Pull the lever, and open the upper cover.
2) Remove the screw, and remove the sheet.
2) Remove the screw, and remove the sheet.
3) Remove the pawl, and remove the take-up roller and the paper
feed roller.
4) Remove the screw, and remove the paper guide block.
5) Remove the pawl, and remove the reverse roller.
5) Remove the pawl, and remove the reverse roller.
2. Each unit removal
A. Paper feed unit
1)
Pull out the tray.
2)
Open the upper cover, and remove three screws.
3)
Remove the upper cabinet.
4)
Disconnect the connectors (2 positions).
5)
Remove the screw, and remove the paper feed unit.
MX-LCX2 DISASSEMBLY AND ASSEMBLY 6 – 2
B. Paper feed tray
1) Pull out the tray.
2) Looser the stopper fixing screw (1) on the lower right side of
2) Looser the stopper fixing screw (1) on the lower right side of
the paper tray, evacuate the stopper not to function.
3) Remove the screws from the left and right rail sections.
4) Remove the tray unit from the rail.
C. Drive unit
1)
Remove the screw, and remove the rear cover.
2)
Remove the connectors (2 positions).
3)
Remove the screw, and remove the drive unit.
3. Major parts removal
A. Motor (Main)
1)
Remove the screw, and remove the rear cover.
2)
Disconnect the connector.
3)
Remove the screw, and remove the motor.
MX-LCX2 DISASSEMBLY AND ASSEMBLY 6 – 3
B. Lift motor
1) Remove the drive unit.
2) Remove the E-ring, and remove the parts.
2) Remove the E-ring, and remove the parts.
3) Remove the screw, and remove the cover.
4) Remove the screw, and remove the lift motor.
5) Remove the ring, and remove the pulley.
C. Clutch
1)
Remove the paper feed unit. (Refer to "3. Each unit removal.")
2)
Remove the screw, and remove the cover.
3)
Remove the E-ring, and remove the parts.
4)
Disconnect the connector, and remove the screw.
5)
Remove the frame.
MX-LCX2 DISASSEMBLY AND ASSEMBLY 6 – 4
6) Remove the connector, and the E-ring, and remove the paper
feed, transport clutch, respectively.
D. Paper feed solenoid
1) Remove the paper feed unit.
2) Remove the cover.
3) Remove the screw, and remove the unit.
2) Remove the cover.
3) Remove the screw, and remove the unit.
4) Disconnect the connector.
5) Remove the screw, and remove the solenoid.
5) Remove the screw, and remove the solenoid.
E. Torque limiter
1)
Remove the paper feed unit.
2)
Remove the cover.
3)
Remove the E-ring and the screw, and remove the parts.
4)
Lift the shaft, and remove the torque limiter.
Click on the first or last page to see other MX-5500N / MX-6200N / MX-7000N (serv.man10) service manuals if exist.