DOWNLOAD Sharp MX-2640N / MX-2640NR / MX-2640FN / MX-3140N / MX-3140NR / MX-3140FN / MX-3640N / MX-3640NR / MX-3640FN (serv.man183) Service Manual ↓ Size: 419.47 KB | Pages: 6 in PDF or view online for FREE

Model
MX-2640N MX-2640NR MX-2640FN MX-3140N MX-3140NR MX-3140FN MX-3640N MX-3640NR MX-3640FN (serv.man183)
Pages
6
Size
419.47 KB
Type
PDF
Document
Service Manual / Technical Bulletin
Brand
Device
Copying Equipment / PREVENTION OF PRIMARY TRANSFER BELT CLEANING BLADE FLIP
File
mx-2640n-mx-2640nr-mx-2640fn-mx-3140n-mx-3140nr-mx.pdf
Date

Sharp MX-2640N / MX-2640NR / MX-2640FN / MX-3140N / MX-3140NR / MX-3140FN / MX-3640N / MX-3640NR / MX-3640FN (serv.man183) Service Manual / Technical Bulletin ▷ View online

3. Remove Cleaner seal F/R (Current one)
4. Clean the affixation face for Cleaner seal F/R (New one) with alcohol.
5. Affix Cleaner seal F/R (New one)
Remove the seal gently not the glue
to be remained.
Reference lines for affixing
(end of blade)
Reference lines 
for affixing
(end of frame)
Reference lines for affixing
(end of blade)
Reference lines 
for affixing
(end of frame)
0mm
0.3mm
0mm
0.3mm
0.3mm
0mm
0mm
0.3mm
Make sure that the blade is not 
positioned onto Cleaner seal.
2 / 4
6. Apply CKOG-0345DS51on to Transfer belt for one rotation.
   (2) Please move the powder until the toner is applied from the front to the rear end of the transfer belt.
7. Install Cleaner UN to 1st transfer UN.
Application
NG
Install Cleaner UN.
Front side
Tighten Step screws on F/R sides. 
(one screw on each side).
Rear side
Apply CKOG-0345DS51 to the belt 
surface without any gap just like 
drawing arc.
(refer to the blue lines in the picture)
◆How to apply◆
(1) Take out the powder from the bag and then gently 
place it on the transfer belt.
(2) Move the powder over the whole transfer belt F-R 
just like drawing arc.
【NOTE】
(1) If you apply the powder with tapping it in the vertical direction against the transfer belt, it will disperse 
and result in "Application NG" state as shown in the following picture.
1st transfer belt
F side
R side
Moving direction of powder
Powder(CKOG-0345DS51)
*Apply the powder up 
to the end section of belt.
Application
OK
3 / 4
8. Make the belt rotate until the yellow toner runs out.
9. Install Transfer rear PG (screw x 4).
4 / 4
8. Make the belt rotate until the yellow toner runs out.
9. Install Transfer rear PG (screw x 4).
4 / 4
Page of 6
Display

Sharp MX-2640N / MX-2640NR / MX-2640FN / MX-3140N / MX-3140NR / MX-3140FN / MX-3640N / MX-3640NR / MX-3640FN (serv.man183) Service Manual / Technical Bulletin ▷ Download