DOWNLOAD Sharp AR-P16 (serv.man12) Service Manual ↓ Size: 122.46 KB | Pages: 1 in PDF or view online for FREE

 

 

 

AR-P16 Print Controller 
 
Note: A Printer and NIC configuration page should be printed, prior to upgrading the firmware. 
 

1. 

Check that the AR-P16 Parallel Printer Port is enabled within the “Custom 
Settings” menu.   (Key Operator – Printer Settings – Interface Settings) 

 

2. 

Power off the copier and remove the AR-P16 printer control board. 

 

3. 

Set the “Write protect” control jumpers as follows and reinstall the control Pwb:- 

 

Boot Program upgrade 

 

Set JP1 to H 

 

 

 

 

Set JP3 to H (Default setting is H) 

 

 

 

2. 

Connect an IEE1284 centronics cable from the parallel port of the PC to the 

 

centronics port of the Print Controller and Power on the copier. 

 

 

4. 

Start Windows and boot to a “Command Prompt” (Windows 98 is preferred). 

 

5. 

When the Printer “Ready Lamp” is displayed, Execute SIM 67-14.  
(Check that “PLEASE SEND DATA“ is displayed.) 

 

 

6. 

Download the file by typing the following command:- COPY/B ***.BLK LPT1: 

 

 

(Download the Boot program first if both Boot & PCL firmware require upgrading). 

 

 

 

The machine will display the following display sequence:- 

 

   

 

 

Note: Never turn off the power during program download. 

   

 

7. 

When “COMPLETED” is displayed, power off the copier. 

 

8. 

Return the Print Controller “Write Protect” Jumper JP1 back to L position and 
power on the copier. 

 

9. 

When the Printer “Ready” lamp is displayed, execute Sim 22-05 to confirm the 
firmware version(s). 

 

10. 

Execute Sim 67-17 to clear the Printer NVRAM. 
(Also execute Sim 67-18 to clear the Printer Flash Data before configuring network 
scanning and entering destinations for the first time only otherwise, ALL existing 
destinations will be erased).  

 

11. 

Perform User colour calibration from within “Custom Settings.