Sharp AR-NC5J (serv.man5) User Manual / Operation Manual ▷ View online
7-8
Print Server Card User Software
Print Server Card
Users Manual
Option
Search by TCP/IP
Search by TCP/IP protocol.
Search with IPX/SPX
Search by IPX/SPX protocol.
Environment Setup
Setup environment for NICManager.
Help
About
Displays NICManager version information.
7-9
Print Server Card User Software
Print Server Card
Users Manual
From the main menu of the NICManager, go to
Setup then select Print Server Card Setup
to configure Print Server Card. You need to type the Password for Print Server Card to open
Print Server Card Setup.
* Password in Factory default is
Sharp.
* With
Guest User rights, you are only able to see to the settings but not configure them.
TIP
7-10
Print Server Card User Software
Print Server Card
Users Manual
2.
After selecting
Setup - IP Address
Setup, IP Address Setup utility
starts. Assign an IP Address and
click on
OK.
3.
Restart the printer to enable the
configuration of IP Address.
Configure IP Address Manually
This section explains how to set IP address to Print Server Card.
* Refer to the Ethernet address of the Print Server Card in advance. Ethernet address is 6
sets of the hexadecimal two digit number written on Print Server Card.
(Ex. : 00.80.92.00.13.67)
Example of IP address setup by NICManager below.
1. Select the Print Server Card you will configure using NICManager from the list. If there are
several Print Server Cards, use Ethernet Address to select correct Print Server Card.
* If error occurs during the assigning
of an IP address, an error message
will be displayed. Check the
Ethernet address and IP address
and try again.
TIP
TIP
7-11
Print Server Card User Software
Print Server Card
Users Manual
Configure General
Go to menu bar of NICManager and select
Setup - Print Server Card Setup and move to
General. This section is a very important part of setup. Check with your network administrator
before setting up.
<Explanation for Each Parameter>
Change admin password:
Set the administrator password of Print Server Card in ASCII characters. This password is
used as the authentication password to change configurations in Telnet, Web pages and
configuration tools.
* Password in Factory default is
Sharp.
Old Password/New Password/Confirm New Password:
Setup administrator password in ASCII. This password will be used when logging into Print
Server Card by TELNET, Web page, and Setup Tool.
Print status page after bootup:
Select whether to Print status page of Print Server Card or not when the printer starts.
TIP
Click on the first or last page to see other AR-NC5J (serv.man5) service manuals if exist.