DOWNLOAD Sharp AR-M550 (serv.man28) Service Manual ↓ Size: 5.25 MB | Pages: 127 in PDF or view online for FREE

●To exit the job programs mode, press the [CA] (clear all) key on the operation panel or touch the [EXIT] key on the

touch panel.

■

■

■

■ If a number key is selected in step 3 that has

A setting confirmation screen will appear. To replace
the existing program with the new program, touch
the [STORE] key and continue from step 4. If you do
not wish to replace the existing program, touch the
[CANCEL] key to return to the screen of step 3 and
select a different number key.

M NUMBER.

RECALL

STORE/DELETE

PROGRAMS

ESS PROGRAM NUMBER.

RECALL

STORE/

B5

B4
B5

A4

1.

3.
4.

2.

SPECIAL MODES

TO STORE, MAKE SELECTIONS AND PRESS

[OK], TO DELETE, PRESS [CANCEL].

2-SIDED COPY

OUTPUT

If overwriting of programmed copy settings has been
prohibited in the key operator programs, you will not
be able to store a job program. (See page 15 of the
key operator's guide.)

AUTO

AUTO

ORIGINAL

OK

NCEL

The screen
automatically closes and
the job program is called
up. A number key that
does not have a job
program cannot be
selected.

Copying will begin using
the settings of the job
program.

If a number key for which
no job program has
been stored is selected,
the screen will change to
the screen of step 4 on
the previous page (for
storing a job program). 

The selected program is
deleted and you return
to the screen of step 3.
To return to the screen
of step 3 without deleting
the job program, touch
the [CANCEL] key. In

both cases, touch the [EXIT] key on the screen
displayed in the screen of step 3 to exit the job
program mode.

JOB PROGRAMS

PRESS PROGRAM NUMBER.

RECALL

M NUMBER.

RECALL

STORE/DELETE

EXIT

STORE/DELETE

If overwriting of programmed copy settings has been
prohibited in the key operator programs, you will not
be able to clear a job program. (See page 15 of the
key operator's guide.)

REC LL

STORE/DELETE

A JOB PROGRAM HAS BEEN ALREADY STORED

IN THIS LOCATION.

CANCEL

DELETE

STORE

The copy of the original scanned in interrupt mode is output before the remainder of the interrupted copy job.

If interrupt copying is
possible during a copy
run, the [INTERRUPT]
key will appear. (If the
key does not appear,
interrupt copying is not
possible.)

When the [INTERRUPT]
key is touched in step 1,
the [INTERRUPT] key
will be replaced by the
[CANCEL] key as shown
in the illustration. 

To cancel an interrupt

copy job while the interrupt original is being
scanned or while you are selecting copy settings,
touch the [CANCEL] key.

NOTES
● If you touch the [INTERRUPT] key when auditing

mode is enabled, the display will prompt you to
enter your account number. Enter your account
number with the numeric keys. The copies you
make will be added to the count of the entered
account number.

● If a copy is being printed when the [INTERRUPT]

key is pressed, interrupt mode will begin after the
copy is finished.

● If the copy run to be interrupted is using paper

from the bypass tray, the paper size and type of
the bypass tray cannot be changed for use by the
interrupt job.

● If the document glass is used for an interrupt copy

job, two-sided copying, sort copying, and staple
sort copying cannot be selected. If any of these
functions are necessary, use the document
feeder.

AUTO

 AUTO

AUTO

A4

ORIGINA

EXPOSUR

A4

23

INTERRUPT

 AUTO

EXPOSURE

AUTO  A4

PAPER SELECT

100%

OPY RATIO

CANCEL

ORIGINAL

0

A4