Sharp AR-FX13 (serv.man3) User Manual / Operation Manual ▷ View online
MODEL
AR-FX13
• INSTALLATION
• INITIAL SETTINGS
• CHOOSING SUITABLE
• INITIAL SETTINGS
• CHOOSING SUITABLE
MEDIA
• HOW TO USE THE FAX
• HOW TO USE THE FAX
FUNCTION
• SPECIAL FUNCTIONS
• TROUBLESHOOTING
• APPENDIX
• SPECIAL FUNCTIONS
• TROUBLESHOOTING
• APPENDIX
11
13
50
52
67
85
92
Page
FACSIMILE EXPANSION KIT
OPERATION MANUAL
Cover1_AR-FX13_sec_fax_sec.fm 1 ページ 2008年2月12日 火曜日 午後2時53分
Note
• This manual (fax function) describes the AR-M201 model with optional
reversing single pass feeder (RSPF) (AR-RP9), and optional facsimile
expansion kit (AR-FX13) installed. Depending on the model you have and
on the options installed, some of the illustrations in this manual may be
different, however, the basic operations are the same.
expansion kit (AR-FX13) installed. Depending on the model you have and
on the options installed, some of the illustrations in this manual may be
different, however, the basic operations are the same.
• This manual describes how to use the fax function of the machine.
Part names and functions shared with the copy function (for example, the
misfeed indicator and add paper indicator), are described in the Operation
Manual (for general information). For more information, please read the
Operation Manual (for general information).
misfeed indicator and add paper indicator), are described in the Operation
Manual (for general information). For more information, please read the
Operation Manual (for general information).
• This operation manual refers to the Reversing Single Pass Feeder as the
"RSPF".
IMPORTANT NOTICE FOR AUSTRALIA AND NEW ZEALAND USERS
Your fax machine and the telephone system
WARNING NOTICE:
NO calls can be made to or from this fax during a mains power failure.
NO calls can be made to or from this fax during a mains power failure.
WARNING — Australian Communications and Media Authority (ACMA) regulations
state that no unauthorised changes or modifications to this equipment are permitted.
state that no unauthorised changes or modifications to this equipment are permitted.
Note: Complies with the following standards,
AS/NZS 60950.1
AS/ACIF S002, NZ TELECOM and CISPR 22
AS/ACIF S002, NZ TELECOM and CISPR 22
These limits are designed to provide reasonable protection against interference in
an installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause interference. However, there is no guarantee that interference will not occur
in a particular installation.
an installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause interference. However, there is no guarantee that interference will not occur
in a particular installation.
If this equipment does cause interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and the receiver.
— Connect the equipment to an outlet on a different circuit to that which the
receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
The Ringer Equivalence Number (REN) for this equipment is written on the A-Tick
label.
label.
Important safety information
In Australia, installing or modifying telephone lines should only be done by an
ACMA licensed serviceman. In New Zealand, installing or modifying telephone
lines should be done in accordance with Telecom wiring practices.
Cover2.fm 1 ページ 2008年2月12日 火曜日 午後2時54分
i
INTRODUCTION
Important safety instructions
• If any of your telephone equipment is not operating properly, you should immediately remove it from your
telephone line, as it may cause harm to the telephone network.
• The AC power outlet shall be installed near the equipment and shall be easily accessible.
• Never install telephone wiring during a lightning storm.
• Never install telephone sockets in wet locations unless the socket is specifically designed for wet locations.
• Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the
• Never install telephone wiring during a lightning storm.
• Never install telephone sockets in wet locations unless the socket is specifically designed for wet locations.
• Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the
network interface.
• Use caution when installing or modifying telephone lines.
• Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of
• Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of
electric shock from lightning.
• Do not use a telephone to report a gas leak in the vicinity of the leak.
• Do not install or use the machine near water, or when you are wet. Take care not to spill any liquids on the
• Do not install or use the machine near water, or when you are wet. Take care not to spill any liquids on the
machine.
• Save these instructions.
!AR-FX13_sec.book i ページ 2008年2月1日 金曜日 午後5時40分
!AR-FX13_sec.book ii ページ 2008年2月1日 金曜日 午後5時40分