Sharp AR-F16 (serv.man2) Service Manual ▷ View online
CHAPTER 1 GENERAL DESCRIPTION
1-13
3. Puncher
Unit
(option)
Figure 1-206
[1] Punch
motor
[6] LED
PCB
[2] Cam
[7] Horizontal
registration
motor
[3]
Hole puncher (Punch blade)
[8]
Scrap full detector PCB unit
[4]
Die
[9]
Punched scrap container
[5] Photosensor
PCB
[1]
[2]
[3]
[4]
[5]
[6]
[6]
[7]
[8]
[9]
CHAPTER 1 GENERAL DESCRIPTION
1-14
III. Using the Machine
A.
Removing Paper Jams
from the Finisher Unit
from the Finisher Unit
If the host machine indicates the finisher
paper jam message, perform the following to
remove the jam.
1)
remove the jam.
1)
Holding the finisher unit as shown, move it to
detach it from the host machine.
detach it from the host machine.
Figure 1-301
2)
Remove any jam visible from the outside.
Figure 1-302
3)
Open the upper cover, and check the inside of
the finisher.
the finisher.
Figure 1-303
4)
Lift the buffer roller cover, and remove the
jam.
jam.
Figure 1-304
5)
Lift the buffer roller, and remove the jam.
Figure 1-305
CHAPTER 1 GENERAL DESCRIPTION
1-15
: Jan. 9 2004
1
6)
Return the buffer roller and the buffer roller
cover to their original positions, and close the
upper cover.
cover to their original positions, and close the
upper cover.
Figure 1-306
7)
Connect the finisher to the host machine.
Figure 1-307
8)
Operate as instructed on the display.
B.
Supplying the Finisher
Unit with Staples
Unit with Staples
If the host machine indicates the finisher unit
staple supply message, perform the following to
supply it with staples.
1) Open the front cover.
supply it with staples.
1) Open the front cover.
Figure 1-308
Figure 1-309
3)
When the staple cartridge has slightly slid
out, hold and pull it out.
out, hold and pull it out.
Figure 1-310
2)
Shift down the green lever.
1
CHAPTER 1 GENERAL DESCRIPTION
1-16
: Jan. 9 2004
1
4)
Hold the empty staple case on its sides, and
slide it out.
slide it out.
Figure 1-311
5)
Set a new staple case.
Figure 1-312
6)
Pull the length of tape (used to hold the sta-
ples in place) straight out.
ples in place) straight out.
Figure 1-313
Figure 1-314
8)
Check to make sure that the stapler has been
locked in place, and close the front cover.
locked in place, and close the front cover.
Figure 1-315
Reference:
You may set no more than one staple cartridge at
a time.
Make sure that the new cartridge is one
specifically designed for the finisher unit.
a time.
Make sure that the new cartridge is one
specifically designed for the finisher unit.
7)
Push in the stapler unit until the green lever
returns to its original position.
returns to its original position.
1
Click on the first or last page to see other AR-F16 (serv.man2) service manuals if exist.