Sharp AR-F11 (serv.man9) Service Manual ▷ View online
CHAPTER 9 UNPACKING AND INSTALLATION
9-8
III. INSERTER (AR-CF1)
WARNING
The unpacking and set-up procedure shall be
done by a qualified service technician.
done by a qualified service technician.
1)
UNPLUG
2)
DISCONNECT
3)
REMOVE
4)
REMOVE
5)
OPEN
6)
REMOVE
Saddle stitch finisher
Non-saddle stitch finisher
When the hole punch unit is installed
When the hole punch unit is not installed
8
9
11
16
22
6
13
8
10
9
15
18
16
BID
M4X12
M4X12
TPPAN
M4X12
M4X12
BID
M4X8
M4X8
BID
M4X8
M4X8
BID
M4X8
M4X8
BID
M4X8
M4X8
CHAPTER 9 UNPACKING AND INSTALLATION
9-9
7)
REMOVE
8)
INSTALL
9)
INSTALL
If a Hole Punch Unit is installed, align the
vertical tab with hole B, if not, align with
hole C.
If a Hole Punch Unit is installed, align the
vertical tab with hole B, if not, align with
hole C.
10) INSTALL
11) INSTALL
12) INSTALL
13) INSTALL
14) INSTALL
15) INSTALL
19
B
C
CHAPTER 9 UNPACKING AND INSTALLATION
9-10
16) INSTALL
17) CONNECT
18) INSTALL
19) INSTALL
20) CONNECT
21) PLUG IN
22) Height adjustment procedure
1.
Put a paper tube on the positioning pin.
2.
Adjust the height of the caster on the rear
side so as to match the center of the
paper tube with that of the inserter hole.
side so as to match the center of the
paper tube with that of the inserter hole.
3.
Match the height of the caster on the
front side with that of the caster on the
rear side.
front side with that of the caster on the
rear side.