View Sharp AR-DU1 (serv.man8) Technical Bulletin online
mainly for the mirror mount fixing plate.
was changed, and the thickness of both the duplex tape and the GID plate for the side
plate was changed.
-Thickness of the GID plate of the side plate was changed from t1.0 to t1.2
the production was changed to a new supplier.
Driver, the part was changed.
9. To improve the productivity, the scanner motor (2 phase 3 phase) and the scanner
driver PWB were changed. In addition to this the mirror motor fixing plate was changed
and the rubber mount and screws ( M4 x 10) were added.
replace the mirror motor fixing plate and the mirror motor mount, including screws at the
same time. The firmware should be updated to the versions below or later.
updated to the version above or later please take the following action in the Sim codes.
trouble code will be indicated, due to the position of the mirror base (initial home base
setting trouble) when the machine boots up.
or 3 phase) is incorrect.
2~4. Running change from June 2002
5. From the first lot of August 2001 (Japan)
From the first lot of September 2001 China)
6. Running change from June 2002 production
7~8. From the first lot of July 2002 production (Japan)
From the first lot of August 2002 production (China)
9. From the first lot of May 2002 production (Japan only)