Sharp AR-DU1 (serv.man19) Service Manual / Technical Bulletin ▷ View online
Page ( 2 / 5 )
(5) In place of Roller support plate, secure Repair part with the screw that had
been fastened originally.
At this point, for Section C, use the screw that had been originally fastened
to secure Earth plate. Fasten Earth plate and Repair part together.
Repair part
Repair part
C
The screw that has been removed in Step 3 above.
Earth plate
(6) Tighten E type ring (P/G No. 2-1) /Ball bearing (P/G No. 2-3) that have been
removed in Step 2 above.
Ball bearing
E type ring
Page ( 3 / 5 )
[If Section D in the picture below is damaged]
Please note that Repair part can be used when Section D in the picture below
is cracked only. If Section D comes off completely, Repair part must not be
used.
Please note that Repair part can be used when Section D in the picture below
is cracked only. If Section D comes off completely, Repair part must not be
used.
D
E
(7) Remove Screw at Section E in the picture above.
(8)
Fasten Repair part by the screw that has been removed from Section E in
the picture above.
the picture above.
Repair part
Repair part
Page ( 4 / 5 )
[If Section F in the picture below is damaged]
Please note that Repair part can be used only if Section F in the picture below
completely comes off. If Section F is cracked Repair part must not be used.
Please note that Repair part can be used only if Section F in the picture below
completely comes off. If Section F is cracked Repair part must not be used.
F
G
Gear(46T)
E type ring
(9)
Remove Screw at Section G in the picture above. Remove also E-type
ring and Gear (46T) in the picture above.
ring and Gear (46T) in the picture above.
(10) Remove E-type ring shown in the picture below.
E type ring
Page ( 5 / 5 )
(11)Fit Repair part. Then fasten E-type ring and Screw at Section H.
Fasten Screw at Section H along with Repair part and Earth terminal.
(12) Fit Gear (46T) and tighten E-type ring.
Gear(46T)
E type ring
E type ring
H
Repair part
Display