DOWNLOAD Sharp AR-C170 (serv.man48) Service Manual ↓ Size: 4.72 MB | Pages: 96 in PDF or view online for FREE

Several points must be kept in mind when using this product as a facsimile. 
Please note the following:

■

■

■

■ Line connection

Use the telephone cable supplied to connect the
machine to a telephone line. Insert the end of the line
cord with the core into the LINE socket on the
machine as shown. Insert the other end into the
telephone line socket.

In some countries, an adapter is required to connect the
telephone line cable to the wall telephone socket, as
shown in the illustration.

■

■

■

■ Fax power switch

When using the machine, be sure to keep the fax power switch turned
on at all times. The fax power switch must be turned on to receive
faxes at night or send timer transmission faxes at night.

■

■

■

■ Settings and programming

Information about settings and programming that are required before the fax functionality can be used is located
in "POINTS TO CHECK AND PROGRAM AFTER INSTALLATION" on page 1-2 of this manual. Please read this
section and perform the required settings and programming.

■

■

■

■ Lithium battery

A lithium battery inside the machine keeps key operator program settings for the fax function in memory.

●

When the battery dies, settings and programmed information will be lost. Be sure to keep a written record of
the settings and programmed information. (Refer to page 6-14.)

●

The life of the lithium battery is approximately 5 years if the machine power switch and fax power switch are
kept continually off.

■

■

■

■ Other information

●

If a thunderstorm occurs, we recommend that you unplug the power cord from the power outlet. Information
will be retained in memory even if the power cord is unplugged.

Core

Line
socket

Adapter

Wall socket

OFF

Fax power switch

ON

ApollonII_fax_ex.book  4 ページ  ２００４年９月２０日　月曜日　午後３時２４分

●

If any of your telephone equipment is not operating properly, you should immediately remove it from your telephone
line, as it may cause harm to the telephone network.

●

The AC power outlet shall be installed near the equipment and shall be easily accessible.

●

Never install telephone wiring during a lightning storm.

●

Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

●

Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the
network interface.

●

Use caution when installing or modifying telephone lines.

●

Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of
electric shock from lightning.

●

Do not use a telephone to report a gas leak in the vicinity of the leak.

●

Do not install or use the machine near water, or when you are wet. Take care not to spill any liquids on the machine.

WARNING NOTICE:
NO calls can be made to or from this fax during a mains power failure.

●

This is a Class A product. In a domestic environment this product may cause radio interference in which case the
user may be required to take adequate measures.

WARNING
Australian Communications Authority (ACA) regulations state that no unauthorised changes or modifications to this
equipment are permitted.

Note: Complies with the following standards,

ACA TS001-1997, AS/NZS 60950:2000
AS/ACIF S002:2001, NZ TELECOM and AS/NZS CISPR 22:2002

These limits are designed to provide reasonable protection against interference in an installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause interference. However, there is no guarantee that interference will not occur in a particular
installation.

If this equipment does cause interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:

●

Reorient or relocate the receiving antenna.

●

Increase the separation between the equipment and the receiver.

●

Connect the equipment to an outlet on a different circuit to that which the receiver is connected.

●

Consult the dealer or an experienced radio/TV technician for help.

The Ringer Equivalence Number (REN) for this equipment is written on the A-Tick label.

In Australia, installing or modifying telephone lines should only be done by an ACA licensed serviceman. In New
Zealand, installing or modifying telephone lines should be done in accordance with Telecom wiring practices.

Whale_00.fm  5 ページ  ２００４年１０月１５日　金曜日　午前９時３８分

ApollonII_fax_ex.book  6 ページ  ２００４年９月２０日　月曜日　午後３時２４分

This chapter contains basic information about using the fax features of
this product. Please read this chapter before using the fax features.

Page

POINTS TO CHECK AND PROGRAM AFTER INSTALLATION..............1-2

CONNECTING AN EXTENSION PHONE ................................................1-2

●

CONNECTING AN EXTENSION PHONE ...................................... 1-2

A LOOK AT THE OPERATION PANEL ....................................................1-3

●

FAX MODE (CONDITION SETTINGS SCREEN)........................... 1-4

ORIGINALS ..............................................................................................1-6

●

ORIGINALS THAT CAN BE FAXED............................................... 1-6

LOADING A DOCUMENT.........................................................................1-7

●

USING THE REVERSING SINGLE PASS FEEDER ...................... 1-7

●

USING THE DOCUMENT GLASS.................................................. 1-7

CHECKING THE SIZE OF A LOADED ORIGINAL...................................1-8

●

MANUALLY SETTING THE SCANNING SIZE ............................... 1-8

SELECTING RESOLUTION AND EXPOSURE SETTINGS.....................1-9

●

SELECTING THE RESOLUTION ................................................... 1-9

●

CONVENIENT DIALING METHODS ........................................................1-11

ApollonII_fax_ex.book  1 ページ  ２００４年９月２０日　月曜日　午後３時２４分