DOWNLOAD Sharp AR-335 (serv.man34) Service Manual ↓ Size: 1.68 MB | Pages: 78 in PDF or view online for FREE

Model
AR-335 (serv.man34)
Pages
78
Size
1.68 MB
Type
PDF
Document
User Manual / Operation Manual
Brand
Device
Copying Equipment / AR280 285 335 Operation Manual-Section 1
File
ar-335-sm34.pdf
Date

Sharp AR-335 (serv.man34) User Manual / Operation Manual ▷ View online

1-1
CHAPTER
1
                                    
  
Page
INSTALLATION REQUIREMENTS
..............................
1-2
CAUTIONS
...............................................
1-3
POWER ON AND OFF
......................................
1-5
Power save modes
.........................................
1-5
INFORMATION FUNCTION
...................................
1-7
USING THE TOUCH PANEL
..................................
1-8
How to use the touch panel
...................................
1-8
Selection of function
........................................
1-8
Function setting icons
.......................................
1-9
CHAPTER 1
GETTING STARTED
This chapter describes the basic information on the
use of this copier.
1-2
CHAPTER
1
INSTALLATION REQUIREMENTS
To ensure safety and proper machine performance, please note the following
before initial installation and whenever the machine is to be relocated.
1.
The copier should be installed near an accessible power outlet for easy
connection.
2.
Be sure to connect the power cord only to a power outlet that meets the
specified voltage and current requirements.
Also make certain the outlet is properly grounded.
For this copier’s power supply requirements, see the name plate
located on the left hand side at the rear corner of the copier.
3.
Do not install the machine where it is:
damp or humid,
exposed to direct sunlight,
extremely dusty,
poorly ventilated,
subject to extreme temperature or humidity changes (e.g., near an air
conditioner or heater).
4.
Since a hard disk drive is built into this copier, place the copier on a firm,
level surface. Choose an area which is not subject to any vibration.
5.
Be sure to allow the required space around the machine for servicing
and proper ventilation.
GETTING STARTED  
Installation requirements
30 cm
(11-13/16")
60 cm
(23-5/8")
60 cm
(23-5/8")
30 cm
(11-13/16")
1-3
CHAPTER
1
CAUTIONS
1.
Do not touch the photoconductive drum. Scratches or
smudges on the drum will cause dirty copies.
2.
The fusing unit is extremely hot.  Exercise care in this area.
3. Since a hard disk drive is built into the copier, be sure to turn the
power switch to the “OFF” position when moving the copier.
Take care not to subject the copier to any vibration or shock.
4.
Do not look directly  at the light source. Doing so may
damage your eyes.
5.
Four installation adjusters are provided on the optional
stand/500-sheet paper drawer.
When moving the machine with the optional stand/
500-sheet paper drawer, be sure to raise the installation
adjusters. After moving the machine, lower the four
installation adjusters until they reach the floor and lock the
two casters at the front of the copier.
6. When copying is interrupted (for example, because the
INTERRUPT function has been used, paper or toner has run out,
a misfeed has occurred, etc.), this copier will store the image
data of the originals read prior to the interruption. If copying of
secret documents is interrupted due to the above reasons, be
sure to either resume the interrupted copying by pressing the
START (
) key, or clear the image data by pressing the CLEAR
ALL (
CA
) key after the interrupt copying is completed or the
trouble is cleared, because the stored data may be printed by
other operators.
GETTING STARTED  
Cautions
   
Fusing unit
Photoconductive
drum
Lock
Release
Adjuster
Lock
Caster
Release
Caution
This product contains a low power laser device. To
ensure continued safety do not remove any cover or
attempt to gain access to the inside of the product. Refer
all servicing to qualified personnel.
At the production line, the output power of
the scanner unit is adjusted to 0.6 MILLI-
WATT PLUS 13.4 PCTS and is maintained
constant by the operation of the Automatic
Power Control (APC).
Cautions on laser
Wave length
785 nm 
±
15 nm
Pulse times
North America: (4.0 
µ
±
4 ns)/7 mm
Europe: (5.4 
µ
±
5.4 ns)/7 mm
Output power
0.25 - 0.50 mW
1-4
CHAPTER
1
   
CAUTION
VORSICHT
ADVARSEL
ADVERSEL
VARNING
VARO!
INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCKS DEFEATED. 
AVOID EXPOSURE TO BEAM.
Laserstrahl
UNSICHTBARE LASERSTRAHLUNG WENN ABDECKUNG GEÖFFNET UND 
SICHERHEITSVERRIEGELUNG ÜBERERÜCKT. NICHT DEM STRAHL AUSSETZEN. 
USYNLIG LASERSTRÅLING VED ÅBNING, NÅR SIKKERHEDSAFBRYDERE ER 
UDE AF FUNKTION. UNDGÅ UDSAETTELSE FOR STRÅLNING.
USYNLIG LASERSTRÅLING NÅR DEKSEL ÅPNES OG SIKKERHEDSLÅS BRYTES.
UNNGÅ EKSPONERING FOR STRÅLEN.
OSYNLIG LASERSTRÅLNING NÄR DENNA DEL ÄR ÖPPNAD OCH SPÄRRAR ÄR 
URKOPPLADE. STRÅLEN ÄR FARLIG. BETRAKTA EJ STRÅLEN. 
AVATTAESSA JA SUOJALUKITUS OHITETTAESSA OLET ALTTIINA NÄKYMÄTÖNTÄ
LASERSÄTEILYLLE. ÄLÄ KATSO SÄTEESEEN. 
CAUTIONS
GETTING STARTED  
Cautions
For Europe:
CLASS 1 LASER PRODUCT
LASER KLASSE 1
LUOKAN 1 LASERLAITE
KLASS 1 LASERAPPARAT
CAUTION
INVISIBLE LASER RADIATION
WHEN OPEN AND INTERLOCKS
DEFEATED. AVOID EXPOSURE
TO BEAM.
VORSICHT
UNSICHTBARE
LASERSTRAHLUNG WENN
ABDECKUNG GEÖFFNET UND
SICHERHEITSVERRIEGELUNG
ÜBERBRÜCKT. NICHT DEM
STRAHL AUSSETZEN.
ADVARSEL
USYNLIG LASERSTRÅLNING
VED ÅBNING, NÅR
SIKKERHEDSBRYDERE ER UDE
AF FUNKTION. UNDGÅ
UDSAETTELSE FOR
STRÅLNING.
VAROITUS!
LAITTEEN KÄYTTÄMINEN
MUULLA KUIN TÄSSÄ
KÄYTTÖOHJEESSA MAINITULLA
TAVALLA SAATTAA ALTISTAA
KÄYTTÄJÄN
TURVALLISUUSLUOKAN 1
YLITTÄVÄLLE
NÄKYMÄTTÖMÄLLE
LASERSÄTEILYLLE.
VARNING
OM APPARATEN ANVÄNDS PÅ
ANNAT SÄTT ÄN I DENNA
BRUKSANVISNING
SPECIFICERATS, KAN
ANVÄNDAREN UTSÄTTAS FÖR
OSYNLIG LASERSTRÅLNING,
SOM ÖVERSKRIDER GRÄNSEN
FÖR LASERKLASS 1.
CLASS 1
LASER PRODUCT
LASER KLASSE 1
For North America:
SAFETY PRECAUTIONS
This Digital Copier is rated Class 1 and complies with 21 CFR 1040.10 and 1040.11 of the CDRH standards.
This means that the copier does not produce hazardous laser radiation. For your safety, observe the
precautions below.
Do not remove the cabinet, operation panel or any other covers.
The copier’s exterior covers contain several safety interlock switches. Do not bypass any safety interlock by
inserting wedges or other items into switch slots.
Page of 78
Display

Click on the first or last page to see other AR-335 (serv.man34) service manuals if exist.