Sharp AL-1457 (serv.man32) User Manual / Operation Manual ▷ View online
74
6. Limited Warranty on Media.
SHARP warrants the disks on which the Software is recorded to be free from defects in materials and
workmanship under normal use for a period of ninety (90) days from the date of purchase as evidenced
by a copy of the receipt. The entire liability of SHARP and/or its Licensors and your exclusive remedy
will be replacement of the disk which fails to meet the limited warranty provided by this Clause 6. A disk
will be replaced when it is returned to SHARP or a SHARP authorized representative with a copy of the
receipt. SHARP will have no responsibility to replace a disk damaged by accident, abuse or
misapplication.
ANY IMPLIED WARRANTIES ON THE DISKS, INCLUDING THE IMPLIED WARRANTIES OF
ANY IMPLIED WARRANTIES ON THE DISKS, INCLUDING THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN
DURATION TO NINETY (90) DAYS FROM THE DATE OF DELIVERY. THIS WARRANTY GIVES
YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY
FROM JURISDICTION TO JURISDICTION.
7. Disclaimer of Warranty on Software.
You expressly acknowledge and agree that use of the Software is at your sole risk. The software and
related documentation are provided "AS IS" and without warranty of any kind and SHARP and SHARP'S
Licensor(s) (for the purpose of provisions 7 and 8, SHARP and SHARP'S Licensor(s) shall be
collectively referred to as "SHARP") EXPRESSLY DISCLAIM ALL WARRANTIES, EXPRESS OR
IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. SHARP DOES NOT
WARRANT THAT THE FUNCTIONS CONTAINED IN THE SOFTWARE WILL MEET YOUR
REQUIREMENTS, OR THAT THE OPERATION OF THE SOFTWARE WILL BE
UNINTERRUPTED OR ERROR-FREE, OR THAT DEFECTS IN THE SOFTWARE WILL BE
CORRECTED. FURTHERMORE, SHARP DOES NOT WARRANT OR MAKE ANY
REPRESENTATIONS REGARDING THE USE OR THE RESULTS OF THE USE OF THE
SOFTWARE OR RELATED DOCUMENTATION IN TERMS OF THEIR CORRECTNESS,
ACCURACY, RELIABILITY, OR OTHERWISE. NO ORAL OR WRITTEN INFORMATION OR
ADVICE GIVEN BY SHARP OR A SHARP AUTHORIZED REPRESENTATIVE SHALL CREATE A
WARRANTY OR IN ANY WAY INCREASE THE SCOPE OF THIS WARRANTY. SHOULD THE
SOFTWARE PROVE DEFECTIVE, YOU (AND NOT SHARP OR A SHARP AUTHORIZED
REPRESENTATIVE) ASSUME THE ENTIRE COST OF ALL NECESSARY SERVICING, REPAIR
OR CORRECTION, SOME JURISDICTIONS DO NOT ALLOW THE EXCLUSION OF IMPLIED
WARRANTIES, SO THE ABOVE EXCLUSION MAY NOT APPLY TO YOU.
8. Limitation of Liability.
UNDER NO CIRCUMSTANCES INCLUDING NEGLIGENCE, SHALL SHARP BE LIABLE FOR
ANY INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES THAT RESULT FROM THE
USE OR INABILITY TO USE THE SOFTWARE OR RELATED DOCUMENTATION, EVEN IF
SHARP OR A SHARP AUTHORIZED REPRESENTATIVE HAS BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES. SOME JURISDICTIONS DO NOT ALLOW THE
LIMITATION OR EXCLUSION OF LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL
DAMAGES SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU.
In no event shall SHARP'S total liability to you for all damages, losses, and causes of action (whether in
contract, tort (including negligence) or otherwise) exceed the amount paid by you for the Software.
9. Controlling Law and Severability.
For a portion of the Software related with Apple Macintosh and Microsoft Windows, this license shall be
governed by and construed in accordance with the laws of the state of California and Washington,
respectively. If for any reason a court of competent jurisdiction finds any provision of this License, or
portion thereof, to be unenforceable, that provision of the License shall be enforced to the maximum
extent permissible so as to effect the intent of the parties, and the remainder of this License shall continue
in full force and effect.
10. Complete Agreement.
This License constitutes the entire agreement between the parties with respect to the use of the Software and
related documentation, and supersedes all prior or contemporaneous understandings or agreements, written
or oral, regarding such subject matter. No amendment to or modification of this License will be binding
unless in writing and signed by a duly authorized representative of SHARP.
MATERIAL SAFETY DATA SHEET
Page: 1/4
Date Revised: Jun. 28. 2002
Date Issued : Jun. 1. 1998
MSDS NO. F-00831
1. PRODUCT AND COMPANY IDENTIFICATION
Product Name
: AL-100TD / DM-150TD / AL-110TD / AL-110DC (Black Toner)
Supplier Identification : Sharp Corporation
22-22 Nagaike-cho, Abeno-ku, Osaka, Japan
Local suppliers are listed below. Please contact the nearest supplier for additional information.
Area
(Country)
(Name and Telephone Number)
U.S.A.
Sharp Electronics Corporation
Sharp Plaza, Mahwah, NJ
Telephone number for information : 1-800-237-4277
Emergency telephone number : 1-800-255-3924
Telephone number for information : 1-800-237-4277
Emergency telephone number : 1-800-255-3924
North
America
Canada
Sharp Electronics of Canada Ltd.
Telephone number for information : 905-890-2100
Emergency telephone number : 1-800-255-3924
Emergency telephone number : 1-800-255-3924
Oceania
Australia
Sharp Corporation of Australia PTY. Ltd.
No1 Huntingwood Drive Huntingwood Blacktown N.S.W.
Telephone number for information : 1300-13-50-22
Telephone number for information : 1300-13-50-22
Germany
Sharp Electronics (Europe) GMBH
Sonninstrasse 3, 20097 Hamburg
Telephone number for information : 040-2376-2613
Telephone number for information : 040-2376-2613
United
Kingdom
Sharp Electronics (U. K.) Ltd.
Telephone number for information : 08705-274-277
France
Sharp Electronics France S.A.
Telephone number for information : 01-49-90-34-00
Austria
Sharp Electronics GMBH
Telephone number for information : 01-727-19-0
Italy
Sharp Electronics (Italy) S.P.A.
Telephone number for information : 02895951
Spain
Sharp Electronics (Espana) S.A.
Telephone number for information : 93-581-97-00
Netherlands
Sharp Electronics Benelux B.V.
Telephone number for information : 30-6359500
Europe
Sweden
Sharp Electronics Nordic AB
Telephone number for information : 08-634-36-00
Middle
East
U.A.E.
Sharp Middle East FZE
P.O.Box 17115 Jebel Ali, Dubai
Telephone number for information : 04-815311
P.O.Box 17115 Jebel Ali, Dubai
Telephone number for information : 04-815311
2. COMPOSITION/INFORMATION ON INGREDIENTS
Substance[ ] Preparation[X]
Ingredient CAS
No. Proportion OSHA
PEL ACGIH
TLV MAK-TWA NOHSC-
TWA
Styrene-Acrylate
copolymer
copolymer
29497-14-1 35-45%
Not listed
Not listed
Not listed
Not listed
Styrene-
homopolymer
homopolymer
9003-53-6 35-45%
Not listed
Not listed
Not listed
Not listed
Carbon black
1333-86-4 5-10%
3.5mg/m
3
3.5mg/m
3
Not listed
3mg/m
3
Iron oxide
1317-61-9 5-10%
Not listed
Not listed
Not listed
Not listed
Polypropylene
9010-79-1 1-5%
Not listed
Not listed
Not listed
Not listed
parafrfine
8002-74-2 1-5%
Not listed
Not listed
Not listed
Not listed
Metal Complex
dye*
dye*
109125-51-1 <1%
0.5mg/m
3
0.5mg/m
3
Not listed
Not listed
84179-66-8
* EC N0. : 400-110-2, Symbol letter : F, R Phrase : R11
MATERIAL SAFETY DATA SHEET
Page: 2/4
Date Revised: Jun. 28. 2002
Date Issued : Jun. 1. 1998
MSDS NO. F-00831
3. HAZARDS IDENTIFICATION
This Preparation is not classified as dangerous according to Directive 1999/45/EC.
Most Important Hazards and Effects of the Products
Human Health Effects : There are no anticipated carcinogenic effects from exposure based on animal tests
Most Important Hazards and Effects of the Products
Human Health Effects : There are no anticipated carcinogenic effects from exposure based on animal tests
performed using toner. When used as intended according to instructions, studies do not
indicate any symptoms of fibrosis will occur.
indicate any symptoms of fibrosis will occur.
Environmental Effects : No data are available.
Specific hazards
Specific hazards
: Dust explosion (like most finely divided organic powders)
4. FIRST-AID MEASURES
Route(s) of Entry : Inhalation?
Skin?
Ingestion?
Yes
No
Possible but very unusual.
Inhalation : Remove to fresh air. If symptoms occur, consult medical personnel.
Skin Contact : Wash with soap and water for 15 minutes or until particle is removed.
Skin Contact : Wash with soap and water for 15 minutes or until particle is removed.
If irritation does occur, consult medical personnel.
Eye Contact : flush eyes immediately with water for 15 minutes. If irritation does occur, consult medical personnel.
Ingestion : Rinse with water and drink several glasses of water . If irritation or discomfort does occur, consult
Ingestion : Rinse with water and drink several glasses of water . If irritation or discomfort does occur, consult
medical personnel.
5. FIRE –FIGHTING MEASURES
Extinguishing Media
: water , CO
2
, foam and dry chemicals
Special Fire fighting Procedures : None
Fire and Explosion Hazards
Fire and Explosion Hazards
: Toner material, like most finely divided organic powders, may form an explosive
mixture.
6. ACCIDENTAL RELEASE MEASURES
Personal Precautions
: None
Environmental Precautions
: None
Methods for Cleaning Up
: Wipe off with paper or cloth. Do not use vacuum cleaner when a large amount
is released. It, like most finely divided organic powders, is capable of creating a
dust explosion.
dust explosion.
7. HANDLING AND STORAGE
Handling
Technical Measures
: None
Precautions
: None
Safe Handling Advice : Use of a dust mask is recommended when handling a large quantity of toner or during
long term exposure, as with any non-toxic dust. Try not to disperse the particles.
Storage
Technical Measures
: None
Storage Conditions
: Keep container closed and Store in a cool and dry place.
Keep out of the reach of children.
Incompatible Products : None
MATERIAL SAFETY DATA SHEET
Page: 3/4
Date Revised: Jun. 28. 2002
Date Issued : Jun. 1. 1998
MSDS NO. F-00831
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Engineering Measures
Ventilation
: Not required under intended use.
Exposure limit values
OSHA-PEL(USA)
: 15mg/m
3
(Total Dust) , 5mg/m
3
(Respirable Dust)
ACGIH-TLV(USA)
: 10mg/m
3
(Total Dust) , 3mg/m
3
(Respirable Dust)
Personal Protective Equipment
Respiratory Protection
: Not required under intended use .
Hand Protection
: Not required under intended use .
Eye Protection
: Not required under intended use .
Skin Protection
: Not required under intended use .
Other Protective equipment
: Use of a dust mask and goggles are recommended when handling a large
quantity of toner or during long term exposure, as with any non-toxic dust.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance
Physical State : Solid
Physical State : Solid
Form: Powder Color: Black
Odor: odorless
Ph : Not applicable
Boiling/Melting Point
Boiling/Melting Point
: Not applicable
Softening Point(°C )
: No data
Flash Point(°C )
: Not applicable
lgnition Point(°C )
: No data
Explosion Properties
: No data
Density(g/cm³) : 1.1 (bulk density : 0.34)
Solubility in water
Solubility in water
: Negligible
10. STABILITY AND REACTIVITY
Stability : Stable
Hazardous Reactions
Hazardous Reactions
: Dust explosion, like most finely divided organic powders.
Conditions to avoid
: Electric discharge, throwing into fire.
Materials to avoid
: Oxidizing Materials
Hazardous Decomposition Products : CO, CO
2
and NO
X
Further Information
: None
11. TOXICOLOGICAL INFORMATION
Acute Toxicity
Ingestion(oral) : LD
50
>2000mg/kg(Rats)
Dermal
: LD
50
>2000mg/kg(Rats)
Inhalation
: No data
Eye
irritation
: Not an irritant
Skin
irritation
: Not an irritant
Skin
sensitizer : No sensitization
Mutagenicity
: Negative(Ames Test)
Carcinogenicity : In 1996 the IARC reevaluated carbon black as a Group 2B carcinogen (possible
human carcinogen). This classification is given to chemicals for which there is
inadequate human evidence, but sufficient animal evidence on which to base an
opinion of carcinogenicity. The classification is based upon the development of lung
tumors in rats receiving chronic inhalation exposures to free carbon black at levels that
induce particle overload of the lung. Studies performed in animal models other than
rats did not show any association between carbon black and lung tumors. Moreover, a
two-year cancer bioassay using a typical toner preparation containing carbon black
demonstrated no association between toner exposure and tumor development in rats.
inadequate human evidence, but sufficient animal evidence on which to base an
opinion of carcinogenicity. The classification is based upon the development of lung
tumors in rats receiving chronic inhalation exposures to free carbon black at levels that
induce particle overload of the lung. Studies performed in animal models other than
rats did not show any association between carbon black and lung tumors. Moreover, a
two-year cancer bioassay using a typical toner preparation containing carbon black
demonstrated no association between toner exposure and tumor development in rats.
Chronic Effect
: In a study in rats of chronic inhalation exposure to a typical toner, a mild to moderate
degree of lung fibrosis was observed in 92% of the rats in the high concentration
(16mg/m
degree of lung fibrosis was observed in 92% of the rats in the high concentration
(16mg/m
3
) exposure group, and a minimal to mild degree of fibrosis was noted in22%
of the animals in the middle (4mg/m
3
) exposure group, but no pulmonary change was
reported in the lowest (1mg/m
3
) exposure group, the most relevant level to potential
human exposures.
Click on the first or last page to see other AL-1457 (serv.man32) service manuals if exist.