DOWNLOAD Sharp PN-655RE (serv.man5) Service Manual ↓ Size: 8.59 MB | Pages: 127 in PDF or view online for FREE

15

E

ENGLISH

You can connect multiple monitors (up to 4 monitors) in a daisy chain by using the PC digital RGB input/
output terminals of this monitor.

Digital signal 
(DVI) cable 
(commercially 
available)

To PC digital 
RGB output 
terminal

Shows the signal 
flow

PC digital RGB
output terminal

PC digital RGB
input terminal

PC digital RGB
input terminal

▼ First monitor

▼ Second monitor

TIPS

• Multiple monitors cannot be connected in a daisy chain for audio. Connect the external audio amplifi er (commercially 

available) to the audio output terminals.

• The length of the signal cables or surrounding environment may affect the image quality.

16

E

Prepare wall-hanging brackets or a stand to mount the monitor unit. Read the manual for the brackets 
or stand for the proper mounting procedure. (The screw holes for mounting brackets (M10 x 4 holes) are 
provided on the rear of the monitor.)

Caution

• The monitor is heavy. It must be handled by three or more people.
• This monitor is fi xed to the temporary stand when shipped from the factory. Please note that this stand is for 

temporary use only until the monitor is properly mounted.

Screws

Screws

1.  Hold the monitor with the handles to prevent 

it from falling down, and remove the stand 
fi xing screws (4).

2.  Lift the monitor by holding it with the handles 

and the underside of the unit.

3.  When the installation is complete, attach the 

included stand hole protection covers, using 
the supplied screws.
(1)  Remove the screws from the monitor 

unit.

(2)  Secure the stand hole protection covers 

with the screws removed in step (1).

•  The temporary stand is specifi cally designed for this monitor. Do not use for other devices.

17

E

ENGLISH

The handles are detachable.

After you removed the handles, be sure to replace the removed screws in the original holes.

18

E

TIPS

• The supplied batteries (2 R-6 batteries) may become exhausted faster depending on the storage condition. It is 

recommended that you replace them with new batteries (commercially available) earlier than specifi ed.

• If you will not use the remote control for a long time, remove the batteries.
• If the remote control does not work, even with new batteries, take the batteries out, check whether they are facing 

the right way, then replace them.

• Use manganese or alkaline batteries only.

The operation range of the remote control unit is approx. 5 m at an angle of approx 10° from the centre 
to the top/bottom/right/left of the remote control sensor.

10°

5m

5m

5m

10°

Remote control sensor

Caution

•  Do not expose the remote control unit to shock by dropping or stepping on it. This could lead to a 

malfunction. 

•  Do not expose the remote control unit to liquids, and do not place it in an area with high humidity.
•  The remote control unit may not work properly if the remote control sensor is under direct sunlight or 

strong lighting. In such cases, change the angle of the lighting, or operate the remote control unit closer 
to the remote control sensor.

•  Objects between the remote control unit and the remote control sensor may prevent proper operation.
•  Replace the batteries when they run low as this may shorten the remote control’s operation range.
•  If a fl uorescent light is illuminated near the remote control unit, it may interfere with proper operation.
•  Do not use it with the remote control of other equipment such as air conditioner, stereo components, 

etc.

1. Press the cover gently and slide it in the direction of the arrow.
2. See the instructions in the compartment and put in the supplied batteries (2 R-6 batteries) with their 

plus (+) and minus (-) sides oriented correctly.

3. Close the cover.