DOWNLOAD Sharp LL-T1811W (serv.man12) Service Manual ↓ Size: 752.85 KB | Pages: 30 in PDF or view online for FREE

8 ~ 10 mm

Screw used to attach arm
Arm

Part of monitor to which
arm is attached

An arm or stand based on the VESA standard
(purchased separately) can be attached to the
monitor.
Procurement of the arm or stand is at the custom-
er's discretion.

Arms or stands able to be used
Attachments must satisfy the following.
-

Compatible with the VESA standard

Have a gap of 100 mm x 100 mm between the
screw holes on the section to be attached

Not be likely to fall off or break off after being
attached to the monitor.

Do not bend the signal cable or the AC adapter
cable nor place weight on them. Doing so could
lead to damage.

While following these instructions, please also
refer to the installation instructions in the
operation manual included with the arm or stand

1. Spread out a soft cloth on a suitable horizontal

surface.

2. Being careful not to damage the monitor, gently

lay the monitor on it display-side down.

3. Remove the stand cover and the covers to the

left and to the right.

4. Remove the two screws, and remove the cover.

5. Remove the four screws and then remove the

stand from the monitor.

6. Attach the arm to the monitor with the four

screws.

CAUTION!
Be careful not to cut or jam your fingers.

The screws used to attach the arm should be M4 screws
with a length of 8 mm ~ 10 mm protruding from the
surface to be attached.
Using different screws could lead to malfunction or may
lead to the monitor falling off,internal damaged,personal
injury

Four screws

Stand

Cover

Two screws

(Rear view)

Stand cover

Lift one side

Cover

Cover