DOWNLOAD Sharp LL-T15A3 (serv.man15) Service Manual ↓ Size: 29.95 KB | Pages: 1 in PDF or view online for FREE

4. Attach the arm to the monitor with four screws.

Note:
- The screws used to attach the arm should be M4

screws with a length of 4 mm ~ 6 mm protruding
from the surface to be attached. Using different
screws could lead to malfunction or may lead to
the monitor falling off, internal damaged,
personal injuly.

4 - 6 mm

5.Connect the AC adapter to the monitor's power

terminal.

An arm or stand based on the VESA standard
(commercially available) can be attached to the
monitor.
Procurement of the arm or stand is at the custom-
er's discretion.

When choosing the arm to be installed please take
note of the following points.
- The arm should be compatible with the VESA

standard, and there must be a gap of 75 mm x
75 mm between the screw holes on the section
to be attached.

- The arm must not fall off or break off after being

attached to the monitor.

Note:
- Do not overly bend the cable or add extension

cords as this could lead to malfunction.

1.Turn off the power switch and remove the AC

adapter from the monitor's power terminal.

2.Being careful not to damage the monitor, spread

out a soft cloth and lay the monitor on it display-
side down.

3.Remove the four screws and then remove the

stand from the monitor.

Notes:
- The stand is specially made for use with this

monitor. Once having removed the stand, never
attempt to attach it to another device.

- Once having removed the screws, store them

together with the stand and if the stand is ever
re-attached be sure to use the original screws.
Using different screws could lead to malfunction.

Screw used to attach arm

Arm

Part of monitor to which arm is
attached