DOWNLOAD Sharp R-82FBSTM (serv.man2) Service Manual ↓ Size: 1.57 MB | Pages: 46 in PDF or view online for FREE

R-82FBSTM - 1

Page

CAUTION, MICROWAVE RADIATION ....................................................................................................   2
WARNING ................................................................................................................................................. 2
SERVICING .............................................................................................................................................  3
PRODUCT SPECIFICATIONS ................................................................................................................. 4
GENERAL INFORMATION ....................................................................................................................... 4
APPEARANCE VIEW ..............................................................................................................................  5
OPERATION SEQUENCE ........................................................................................................................ 6
FUNCTION OF IMPORTANT COMPONENTS .....................................................................................  10
TROUBLESHOOTING GUIDE ............................................................................................................... 12
TEST PROCEDURES ...........................................................................................................................  13
TOUCH CONTROL PANEL ASSEMBLY ............................................................................................... 19
COMPONENT REPLACEMENT AND ADJUSTMENT PROCEDURE ..................................................  25
MICROWAVE MEASUREMENT ...........................................................................................................   31
TEST DATA AT A GLANCE/WIRING AND REWIRING ......................................................................... 32
SCHEMATIC DIAGRAMS ......................................................................................................................  33
PICTORIAL DIAGRAM ..........................................................................................................................  37
POWER UNIT CIRCUIT DIAGRAM ........................................................................................................ 38
CPU UNIT CIRCUIT DIAGRAM .............................................................................................................. 39
PRINTED WIRING BOARD OF POWER UNIT DIAGRAM .................................................................... 40
PARTS LIST ..........................................................................................................................................  41
EXPLODED DIAGRAM OF OVEN PARTS ...........................................................................................  44
CONTROL PANEL & DOOR PARTS ..................................................................................................... 45
MISCELLANEOUS/PACKING & ACCESSORIES .................................................................................. 46

S6578R82FBSTM

In interests of user-safety the oven should be restored to its original
condition and only parts identical to those specified should be used.

®

R-82FBSTM - 2

This Manual has been prepared to provide Sharp Corp. Service engineers with Operation and Service Information.

It is recommended that service engineers carefully study the entire text of this manual, so they will be qualified to render
satisfactory customer service.

WARNING

Never operate the oven until the following points are ensured.
(A) The door is tightly closed.
(B) The door brackets and hinges are not defective.
(C) The door packing is not damaged.
(D) The door is not deformed or warped.
(E) There is not any other visible damage with the oven.

Servicing and repair work must be carried out only by trained
service engineers.

All the parts marked “*” on parts list are used at voltages more than
250V.

Removal of the outer wrap gives access to potentials above 250V.

All the parts marked “∆” on parts list may cause undue microwave
exposure, by themselves, or when they are damaged, loosened or
removed.

Never operate the Grill and/ or  Bottom heater with the oven
outer cabinet removed. (Because air flow is eliminated, and the
excess heat generated on adjacent components). It can cause
permanent damage or a fire.

WARNING

MICROWAVE RADIATION

Personnel should not be exposed to the microwave energy
which may radiate from the magnetron or other microwave
generating devices if it is improperly used or connected. All
input and output microwave connections, waveguides, flanges
and gaskets must be secured. Never operate the device without
a microwave energy absorbing load attached. Never look into
an open waveguide or antenna while the device is energized.

®

R-82FBSTM - 3

1) Disconnect the supply.
2) Door opened, and wedged open.
3) Discharge high voltage capacitor.

The high-voltage capacitor remains charged about 60 sec-
onds after the oven has been switched off. Wait for 60
seconds and then short-circuit the connection of the high-
voltage capacitor (that is, of the connecting lead of the high-
voltage rectifier) against the chassis with the use of an
insulated screwdriver.

Sharp recommend that wherever possible fault-finding is
carried out with the supply disconnected. It may in, some
cases, be necessary to connect the supply after the outer
case has been removed, in this event carry out 3D checks and
then disconnect the leads to the primary of the High voltage
transformer. Ensure that these leads remain isolated from
other components and the oven chassis. (Use insulation tape
if necessary.) When the testing is completed carry out 3D
checks and reconnect the leads to the primary of the High
voltage transformer.

Microwave ovens contain circuitry capable of producing very high voltage and current, contact with following parts will
result in electrocution.
High voltage capacitor, High voltage transformer, Magnetron, High voltage rectifier assembly, High voltage harness.

1) Reconnect all leads removed from components during
testing.
2) Replace the outer case (cabinet).
3) Reconnect the supply.
4) Run  the oven. Check all functions.

Microwave ovens should not be run empty. To test for the
presence of microwave energy within a cavity, place a cup of
cold water on the oven turntable, close the door and set the
power to HIGH and set the microwave timer for two (2) minutes.
When the two minutes has elapsed (timer at zero) carefully
check that the water is now hot. If the water remains cold carry
out 3D checks and re-examine the connections to the compo-
nent being tested.

When all service work is completed, and the oven is fully
assembled, the microwave power output should be checked and
a microwave leakage test should be carried out.

When troubleshooting the microwave oven, it is helpful to
follow the Sequence of Operation in performing the
checks. Many of the possible causes of trouble will
require that a specific test be performed. These tests are
given a procedure letter which will be found in the "Test
Procedure" section.

If the oven becomes inoperative because of
a blown fuse F1 in the monitored latch switch
- monitor switch - circuit, check the monitored
latch switch and monitor switch and before
replacing the fuse F1.

R-82FBSTM - 4

Power Requirements

230 - 240 Volts / 50 Hertz / Single phase, 3 wire earthed

Power Consumption

Microwave cooking

1.50 kW  Approx. 6.5 A

Convection cooking

1.91 kW  Approx. 8.0 A

Top Grill mode ...................... 1.25 kW

Approx. 5.2 A

Grill cooking

Bottom Grill mode ................. 0.70 kW

Approx. 2.9 A

Top and Bottom  mode ......... 1.90 kW

Approx. 7.9 A

Micro and Top Grill ............... 2.70 kW

Approx. 11.5 A

Dual cooking Micro and Bottom Grill .......... 2.15 kW

Approx. 9.2 A

Micro and Convection ........... 2.16 kW

Approx. 9.3 A

Power Output

900 W nominal of RF microwave energy (measured by method of IEC 60705)
Operating fequency 2450 MHz

Top Grill  heating element Power Output

1200 W

Bottom heating element Power Output

650 W

Case Dimensions

Width 520 mm

Height 309 mm (including foot)

Depth 482 mm

Cooking Cavity Dimensions

Width  353 mm

Height 207 mm

Depth 357 mm

Turntable diameter

325 mm

Control Complement

Twin Jog Control System

Clock (1:00 - 12:59) / Timer (0 - 99 minutes 90 sec.)

Microwave Power for Variable Cooking

 Repetition Rate;
100 (HIGH) ....................... Full power throughout the cooking time
70 (MEDIUM HIGH) .........................  approx. 70% of FULL Power
50 (MEDIUM) ...................................  approx. 50% of FULL Power
30 (MEDIUM LOW) ..........................  approx. 30% of FULL Power
10 (LOW) .........................................  approx. 10% of FULL Power

Convection temperature control range:

   250˚C, 230˚C, 220˚C, 200˚C, 180˚C, 160˚C, 130˚C, 100˚C, 70˚C and 40˚C

LESS/MORE buttons, INFO button, AUTO COOK button, PIZZA button,
AUTO DEFOST button, POWER LEVEL button, CONV. (˚C) button,
STOP/CLEAR button, KITCHEN TIMER/CLOCK SET button, 

+

 1min /

START button.

Net Weight

Approx. 19 kg

THE WIRES IN THIS MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:

GREEN-AND-YELLOW

: EARTH

BLUE

: NEUTRAL

BROWN

: LIVE