DOWNLOAD Sharp R-795M (serv.man27) Service Manual ↓ Size: 35.86 KB | Pages: 4 in PDF or view online for FREE

33

If you think the oven is not working properly
there are some simple checks you can carry out
yourself before calling an engineer. This will help
prevent unnecessary service calls if the fault is
something simple.
Follow this simple check below:
Place half a cup of water on the turntable and
close the door. Programme the oven to cook for
1 minute using 100% microwave power.
1. Does the oven lamp come on when it is

cooking?

2. Does the turntable rotate?
3. Does the cooling fan work? (Check by placing

your hand above the air vent openings.)

4. After 1 minute does the audible signal sound?
5. Is the water in the cup hot?
Take the cup of water out of the oven and close
the door. Programme the oven to cook for 3
minutes using the top and bottom grills.
6. After 3 minutes, do both the grill heating

elements become red?

Programme the oven to cook for 3 minutes using
the oven on 180ºC.
7. After 3 minutes, is the oven cavity hot?

If you answer “NO” to any question first check
that the oven is plugged in properly and the fuse
has not blown. If there is no fault with either,
check against the troubleshooting chart on the
following page.

NOTES:
• If you cook food for more than the standard

time (see chart opposite) using the same
cooking mode, the oven’s safety mechanisms
automatically activate. The microwave power
level will be reduced or the grill heating
elements will turn on and off.

• After manual or automatic cooking using the

Grill, Dual Grill or Oven modes, the cooling
fan will switch on to cool the oven cavity.
When the cooling fan works, the display may
show “NOW COOLING”. To clear it, press
the STOP/CLEAR key and the display will
return to the time of day, if set.
During these modes, the cooling fan will carry
on working after you have pressed the
STOP/CLEAR key. You may feel hot air
blowing out of the air-vent openings.

IMPORTANT:
If the display is blank and has gone dark, even if
the power plug is properly connected, the oven
may be in Energy Save Mode. To cancel it, open
and then close the oven door, see page 8.

• The door seal stops microwave leakage during

oven operation, but does not form an airtight
seal. It is normal to see drops of water, light or
feel warm air around the oven door. Food with
a high moisture content will release steam and
cause condensation inside the door which may
drip from the oven.

• Repairs and Modifications: Do not attempt to

operate the oven if it is not working properly.

• Outer Cabinet & Lamp Access: Never remove

the outer cabinet. This is very dangerous due
to high voltage parts inside which must never
be touched, as this could be fatal.
Your oven is not fitted with a lamp access
cover. If the lamp fails, do not attempt to
replace the lamp yourself, call a SHARP
approved service facility.

Microwave 100%
cooking
Grill-1
Grill-2
Grill-3

Dual Grill-1

Microwave 100%

Microwave 10 - 70%

Dual Grill-2

Microwave 100%

Microwave 10 - 70%

20 Minutes

15 Minutes
15 Minutes
Top Grill 6 Minutes
Btm Grill 6 Minutes

Microwave 20 Minutes
Top Grill 15 Minutes
Top Grill 15 Minutes

Microwave 20 Minutes
Btm Grill 15 Minutes
Btm Grill 15 Minutes

R-795M New style Op man  4/8/02  9:21 AM  Page 33

34

When the oven is working, air circulates within the cavity.
The door does not form an airtight seal so air may escape from the door.

The oven cavity will normally be colder than the food being cooked, and so
steam produced when cooking will condense on the colder surface.
The amount of steam produced depends on the water content of the food
being cooked. Some foods, such as potatoes have a high moisture content.
Condensation trapped in the door glass should clear after a few hours.

Arcing will occur when a metallic object comes into close proximity to
the oven cavity during cooking. This may possibly roughen the surface of
the cavity, but would not otherwise damage the oven. 

Ensure all “eyes” are removed and the potatoes have been pierced, place
directly onto the turntable or in a heat resistant flan dish or similar.

Check the door is closed properly.

Ensure correct power level has been selected.

The microwave energy pulses ON and OFF during cooking/defrosting.

The cabinet may become warm to the touch - keep children away.

Draught circulates
around the door.

Condensation forms in
the oven, and may drip
from the door.

Flashing or arcing from
within the cavity when
cooking.

Arcing potatoes.

The display is lit but the
control panel will not
work when pressed.

Oven cooks too slowly.

Oven makes a noise.

Outer cabinet is hot.

R-795M New style Op man  4/8/02  9:21 AM  Page 34

35

The wires in the mains cable are colour coded as
shown:
Green and yellow stripes

=

Blue

=

Brown

=

As the colours in the mains lead of your oven
may not correspond with the coloured marking
identifying the terminals in your plug, connect the
wires as described:
• The green and yellow wire to the plug terminal

marked E or

or coloured green or

coloured green and yellow.

• The blue wire to the plug terminal marked N

or coloured black or coloured blue.

• The brown wire to the plug terminal marked L

or coloured red or coloured brown.

Make sure the terminal screws are tight and the
cable is held securely by the cable grip where it
enters the plug.

Like most appliances in your home, your oven
must be connected to a single phase 230-240V,
50Hz alternating current supply.

If you do not make the proper electrical
connections you might damage the oven or injure
yourself. Neither SHARP nor the supplier will be
liable if this happens.

• If you are unable to resolve a problem using

the checks covered on the last few pages, do
not attempt to service this microwave
oven yourself.

• Contact the dealer or supplier from whom the

oven was purchased in order to obtain service.
Where this is not possible, please contact the
SHARP Customer Information Centre.
Telephone: 08705 274277 (office hours).

• For general information and assistance with

oven queries, please contact our
Customer Information Centre:
U.K.: 08705 274277 (office hours)
Ireland: 01 676 0648 (office hours)
Website: http://www.sharp.co.uk/support

• Replacement accessories may be obtained

from our main parts distributor: 
Willow Vale Electronics Ltd.
Telephone: 0121 766 5414

R-795M New style Op man  4/8/02  9:21 AM  Page 35

35

The wires in the mains cable are colour coded as
shown:
Green and yellow stripes

=

Blue

=

Brown

=

As the colours in the mains lead of your oven
may not correspond with the coloured marking
identifying the terminals in your plug, connect the
wires as described:
• The green and yellow wire to the plug terminal

marked E or

or coloured green or

coloured green and yellow.

• The blue wire to the plug terminal marked N

or coloured black or coloured blue.

• The brown wire to the plug terminal marked L

or coloured red or coloured brown.

Make sure the terminal screws are tight and the
cable is held securely by the cable grip where it
enters the plug.

Like most appliances in your home, your oven
must be connected to a single phase 230-240V,
50Hz alternating current supply.

If you do not make the proper electrical
connections you might damage the oven or injure
yourself. Neither SHARP nor the supplier will be
liable if this happens.

• If you are unable to resolve a problem using

the checks covered on the last few pages, do
not attempt to service this microwave
oven yourself.

• Contact the dealer or supplier from whom the

oven was purchased in order to obtain service.
Where this is not possible, please contact the
SHARP Customer Information Centre.
Telephone: 08705 274277 (office hours).

• For general information and assistance with

oven queries, please contact our
Customer Information Centre:
U.K.: 08705 274277 (office hours)
Ireland: 01 676 0648 (office hours)
Website: http://www.sharp.co.uk/support

• Replacement accessories may be obtained

from our main parts distributor: 
Willow Vale Electronics Ltd.
Telephone: 0121 766 5414

R-795M New style Op man  4/8/02  9:21 AM  Page 35