Sharp VENTA HANDHELD (serv.man10) User Manual / Operation Manual ▷ View online
11
5. Insert the plastic hinge,
or attach the hand strap.
(Refer to Chapter
3 - Attaching the hand
strap).
6. Charge the battery.
Open the power jack cover. Plug the AC adaptor power cord into an
electrical outlet, then connect the DC plug of the adaptor cable to the
OT-200. It takes approximately 6 hours to fully charge the battery for the
first time. Subsequent charges might take longer.
CAUTION
To avoid damaging OT-200 or the AC adaptor,
make sure all connectors are properly
connected.
7. Press Power Button for
three seconds to turn on
OT-200.
• To turn off OT-200.
Press Power Button for
three seconds. At the
prompt, tap Power Off.
12
C H A P T E R 1 G E T T I N G S TA R T E D
Using the cradle
The charging cradle allows a more convenient way to charge OT-200. You can charge a spare battery
(optional) individually or simultaneously as well.
Charge the device in cradle
1. Plug the AC adaptor power cord into an electrical
outlet, then connect the DC plug of the adaptor
cable to the power jack at the back of cradle.
2. Insert OT-200 into the cradle with front of device on
same side as front of cradle.
3. When device is inserted into cradle correctly, the
Power LED on top left of device should turn red.
Device charging is complete when the device Power
LED turns green.
LED turns green.
Charge the battery in cradle
1. Plug the AC adaptor power cord into an electrical outlet, then connect the DC plug of the adaptor cable to
the power jack at the back of cradle.
2. Align the battery connectors on the battery with the
pins in the second battery slot of the cradle, then
install the battery in the direction of the arrow.
3. When battery is inserted into cradle correctly, the
battery LED on the cradle should light up red.
Battery charging is complete when the battery LED
on the cradle turns green.
IMPORTANT
To protect and prolong the life of the battery, do not charge it for 24
hours or longer at a time.
If battery is not used, please store in dry area, ideally with storage
temperature around 25˚C, or within a temperature range of -10˚C ~
30˚C to maximize longevity.
IMPORTANT
13
Changing the battery
Refer to the following to change the battery.
1. Press the Power button
to turn off the OT-200.
2. Remove the plastic
hinge or the bottom of
the hand strap.
Slide the plastic hinge or hand strap down and away from the battery
cover.
3. Remove the screw if the
battery cover is locked.
Please make sure to perform 3 complete full charge and discharge
cycles to get optimal battery capacity. Failure to comply will result in
shorter battery lifespan.
IMPORTANT
14
C H A P T E R 1 G E T T I N G S TA R T E D
4. Remove the battery
cover.
Slide the cover down, then lift up to remove.
5. Remove the battery by
pulling on the plastic
flap.
6. Install the new battery.
Align the battery connectors on the battery with the pins in the battery
compartment and insert the battery.
Click on the first or last page to see other VENTA HANDHELD (serv.man10) service manuals if exist.