Sharp XL-T200 (serv.man15) Service Manual ▷ View online
XL-T200H
– 2 –
Before returning the unit to the customer after completion of a
repair or adjustment it is necessary for the following withstand
voltage test to be applied to ensure the unit is safe for the
customer to use.
Setting of Withstanding Voltage Tester and set.
repair or adjustment it is necessary for the following withstand
voltage test to be applied to ensure the unit is safe for the
customer to use.
Setting of Withstanding Voltage Tester and set.
Set name
set value
Withstanding Voltage Tester
Test voltage
4,240 VPEAK
3,000 VRMS
3,000 VRMS
Set time
6 secs
Set current(Cutoff current)
4 mA
Unit
Judgment
OK: The “GOOD” lamp lights.
NG: The “NG” lamp lights and the buzzor sounds.
NG: The “NG” lamp lights and the buzzor sounds.
This product is classified as a CLASS 1 LASER PRODUCT.
Precaution to be taken when replacing and servicing the
Laser Pickup.
Laser Pickup.
The AEL (Accessible Emission Level) of Laser Power Output is
less than Class 1 but the laser component is capable of emitting
radiation exceeding the limit for Class1. Therefore it is important
that the following precautions must be observed during servicing
to protect your eyes against exposure to the Laser beam.
(1) When the cabinet has been removed, the power is turned
less than Class 1 but the laser component is capable of emitting
radiation exceeding the limit for Class1. Therefore it is important
that the following precautions must be observed during servicing
to protect your eyes against exposure to the Laser beam.
(1) When the cabinet has been removed, the power is turned
on without a compact disc, and the Pickup is on a position
outer than the lead-in position, the Laser will light for several
seconds to detect a disc. Do not look into the Pickup Lens.
outer than the lead-in position, the Laser will light for several
seconds to detect a disc. Do not look into the Pickup Lens.
(2) The Laser Power Output of the Pickup inside the unit and
replacement service parts have already been adjusted prior
to shipping.
to shipping.
(3) No adjustment to the Laser Power should be attempted
when replacing or servicing the Pickup.
(4) Under no circumstances look directly into the Pickup Lens
at any time.
(5) CAUTION - Use of controls or adjustments, or performance
of procedures other than those specified herein may result
in hazardous radiation exposure.
in hazardous radiation exposure.
SAFETY PRECAUTION FOR SERVICE MANUAL
IMPORTANT SERVICE NOTES (FOR U.K. ONLY)
PROBE
AC
OUT
UNIT
SHORT-CIRCUT
AC POWER
SUPPLY CORD
AC POWER
SUPPLY CORD
WITHSTANDING
VOLTAGE TESTER
Screw
Laser Diode Properties
Material: GaAIAs
Wavelength: 780 nm
Emission Duration: continuous
Laser Output: max. 0.6 mW
Wavelength: 780 nm
Emission Duration: continuous
Laser Output: max. 0.6 mW
VAROITUS! LAITTEEN KÄYTTÄMINEN MUULLA KUIN TÄSSÄ
KÄYTTÖOHJEESSA MAINITULLA TAVALLA SAATTAA
A L T I S T A A K Ä Y T T Ä J Ä N T U R V A L L I S U U S L U O K A N 1
YLITTÄVÄLLE NÄKYMÄTTÖMÄLLE LASERSÄTEILYLLE.
KÄYTTÖOHJEESSA MAINITULLA TAVALLA SAATTAA
A L T I S T A A K Ä Y T T Ä J Ä N T U R V A L L I S U U S L U O K A N 1
YLITTÄVÄLLE NÄKYMÄTTÖMÄLLE LASERSÄTEILYLLE.
VARNING - OM APPARATEN ANVÄNDS PÅ ANNAT SÄTT ÄN
I D E N N A B R U K S A N V I S N I N G S P E C I F I C E R A S . K A N
A N V Ä N D A R E N U T S Ä T T A S F Ö R O S Y N L I G L A S E R -
S T R Å L N I N G , S O M Ö V E R S K R I D E R G R Ä N S E N F Ö R
L A S E R K L A S S 1 .
I D E N N A B R U K S A N V I S N I N G S P E C I F I C E R A S . K A N
A N V Ä N D A R E N U T S Ä T T A S F Ö R O S Y N L I G L A S E R -
S T R Å L N I N G , S O M Ö V E R S K R I D E R G R Ä N S E N F Ö R
L A S E R K L A S S 1 .
ADVERSEL-SYNLIG OG USYNLIG LASERSTRÅLING VED ÅBNING.
SE IKKE IND I STRÅLEN-HELLER IKKE MED OPTISKE INSTRUMENTER.
SE IKKE IND I STRÅLEN-HELLER IKKE MED OPTISKE INSTRUMENTER.
VARO! AVATTAESSA OLET ALTTIINA NÄKYVÄLLE JA NÄKYMÄTTÖMÄLLE
LASERSÄTEILYLLE ÄLÄ TUIJOTA SÄTEESEEN ÄLÄKÄ KATSO SITÄ
OPTISEN LAITTE EN LÄPI.
VARNING-SYNLIG OCH OSYNLIG LASERSTRÅLNING NÄR DENNA
DEL ÄR ÖPPNAD. STIRRA EJ IN I STRÅLEN OCH BETRAKTA EJ
STRÅLEN GENOM OPTISKT INSTRUMENT.
LASERSÄTEILYLLE ÄLÄ TUIJOTA SÄTEESEEN ÄLÄKÄ KATSO SITÄ
OPTISEN LAITTE EN LÄPI.
VARNING-SYNLIG OCH OSYNLIG LASERSTRÅLNING NÄR DENNA
DEL ÄR ÖPPNAD. STIRRA EJ IN I STRÅLEN OCH BETRAKTA EJ
STRÅLEN GENOM OPTISKT INSTRUMENT.
– 3 –
XL-T200H
SPECIFICATIONS
Specifications for this model are subject to change without
prior notice.
prior notice.
FOR A COMPLETE DESCRIPTION OF THE OPERATION OF THIS UNIT, PLEASE REFER
TO THE OPERATION MANUAL.
TO THE OPERATION MANUAL.
■
General
■
Amplifier
Power source
AC 230 V, 50 Hz
Power consump-
tion
tion
Power on: 26 W
Power stand-by: 0.6 W
Dimensions
Width: 290 mm (11-7/16")
Height: 130 mm (5-1/8")
Depth: 260 mm (10-1/4")
Height: 130 mm (5-1/8")
Depth: 260 mm (10-1/4")
Weight
2.8 kg (6.2 lbs.)
Output power
PMPO: 30 W (total)
MPO: 15 W (7.5 W + 7.5 W) (DIN 45 324)
RMS: 10 W (5 W + 5 W) (DIN 45 324)
Output terminals
Speakers: 4 ohms
Headphones: 16 - 50 ohms (recommended:
32 ohms)
32 ohms)
Input terminals
Video/Auxiliary (audio signal): 500 mV/47
kohms
kohms
■
CD player
■
Tuner
■
Cassette deck
■
Speaker
Type
Compact disc player
Signal readout
Non-contact, 3-beam semiconductor laser
pickup
pickup
D/A converter
1-bit D/A converter
Frequency re-
sponse
sponse
20 - 20,000 Hz
Dynamic range
90 dB (1 kHz)
Frequency range
FM: 87.5 - 108 MHz
AM: 522 - 1,620 kHz
Frequency re-
sponse
sponse
50-14,000 Hz (Normal tape)
Signal/noise ratio
50 dB (recording/playback)
Wow and flutter
0.3 % (DIN 45 511)
Tweeter
2-way type speaker system
Tweeter
10 cm (4") Woofer
Maximum input
power
power
10 W
Rated input power
5 W
Impedance
4 ohms
Dimensions
Width: 146 mm (5-3/4")
Height: 267 mm (10-9/16")
Depth: 186 mm (7-3/8")
Height: 267 mm (10-9/16")
Depth: 186 mm (7-3/8")
Weight
1.5 kg (3.3 lbs.)/each
XL-T200H
– 4 –
NAMES OF PARTS
■
Front panel
1. CD/Cassette Compartment
2. Function Selector Button
3. Bass/Treble Selector Button
4. Memory/Set Button
5. Tape Record Pause Button
6. Volume Up and Down Buttons
7. CD or Tape Open/Close Button
8. CD Track Down or Fast Reverse, Tape Rewind,
2. Function Selector Button
3. Bass/Treble Selector Button
4. Memory/Set Button
5. Tape Record Pause Button
6. Volume Up and Down Buttons
7. CD or Tape Open/Close Button
8. CD Track Down or Fast Reverse, Tape Rewind,
Tuner Preset Down Button
9. CD Track Up or Fast Forward, Tape Fast Forward,
Tuner Preset Up Button
10. CD or Tape Stop, Tuning Down Button
11. CD Play or Pause, Tape Play, Tuning Up Button
12. On/Stand-by Button
11. CD Play or Pause, Tape Play, Tuning Up Button
12. On/Stand-by Button
■
Display
1. Timer Play Indicator
2. Tape Record Indicator
3. Sleep Indicator
4. CD Random Play Indicator
5. Memory Indicator
6. RDS Indicator
7. Traffic Programme Indicator
8. Traffic Announcement Indicator
9. FM Stereo Mode Indicator
2. Tape Record Indicator
3. Sleep Indicator
4. CD Random Play Indicator
5. Memory Indicator
6. RDS Indicator
7. Traffic Programme Indicator
8. Traffic Announcement Indicator
9. FM Stereo Mode Indicator
10. CD Play Indicator
11. CD Repeat Play Indicator
12. FM Stereo Receiving Indicator
11. CD Repeat Play Indicator
12. FM Stereo Receiving Indicator
1
3
4
5
6 7 8 9
11
10
12
2
1
2
3
4
5
6
7
8
9
10
11
12
■
Rear panel
1. Speaker Terminals
2. Headphone Socket
3. AM Aerial Terminal
4. Aerial Earth Terminal
5. FM 75 Ohms Aerial Socket
6. Video/Auxiliary (Audio Signal) Input Sockets
7. AC Power Input Socket
2. Headphone Socket
3. AM Aerial Terminal
4. Aerial Earth Terminal
5. FM 75 Ohms Aerial Socket
6. Video/Auxiliary (Audio Signal) Input Sockets
7. AC Power Input Socket
■
Speaker system
1. Tweeter
2. Woofer
3. Bass Reflex Duct
4. Speaker Wire
2. Woofer
3. Bass Reflex Duct
4. Speaker Wire
Speaker grilles are removable:
Placing the speaker system:
There is no distinction between the right and the left speakers.
There is no distinction between the right and the left speakers.
3
2
1
4
5
6
7
4
1
2
3
Make sure nothing comes into contact with the
speaker diaphragms when you remove the
speaker grilles.
speaker diaphragms when you remove the
speaker grilles.
Left speaker
Right speaker
– 5 –
XL-T200H
■
Remote control
1. Remote Control Transmitter
2. On/Stand-by Button
3. CD Button
4. Tuner and Band Selector Button
5. Timer Button
6. Clock Button
7. Memory Button
8. Dimmer Button
9. Volume Up and Down Buttons
2. On/Stand-by Button
3. CD Button
4. Tuner and Band Selector Button
5. Timer Button
6. Clock Button
7. Memory Button
8. Dimmer Button
9. Volume Up and Down Buttons
10. Video/Auxiliary Button
11. Tape Button
12. Clear Button
13. Sleep Button
14. Random/Repeat Button
15. CD or Tape Open/Close Button
16. Tape Record Pause Button
17. Tuner Preset Up Button
18. CD Track Down Button
19. CD Fast Reverse, Tuning Down,
11. Tape Button
12. Clear Button
13. Sleep Button
14. Random/Repeat Button
15. CD or Tape Open/Close Button
16. Tape Record Pause Button
17. Tuner Preset Up Button
18. CD Track Down Button
19. CD Fast Reverse, Tuning Down,
Tape Rewind Button
20. CD or Tape Play Button
21. CD Track Up Button
22. CD Fast Forward, Tuning Up,
21. CD Track Up Button
22. CD Fast Forward, Tuning Up,
Tape Fast Forward Button
23. CD Pause Button
24. CD or Tape Stop Button
25. Tuner Preset Down Button
26. Bass Up and Down Buttons
27. Treble Up and Down Buttons
28. RDS Programme Type/
24. CD or Tape Stop Button
25. Tuner Preset Down Button
26. Bass Up and Down Buttons
27. Treble Up and Down Buttons
28. RDS Programme Type/
Traffic Information Search Button
29. RDS ASPM (Auto Station Programme Memory) Button
30. RDS Display Mode Selector Button
30. RDS Display Mode Selector Button
Buttons with " " mark in the illustration can be operated on the re-
mote control only.
mote control only.
1
2
3
4
5
5
6
7
7
8
9
10
11
12
13
14
14
15
17
21
22
23
18
19
20
24
25
26
27
28
29 30
16
