Sharp XL-3000 User Manual / Operation Manual ▷ View online
33
XL-3000H(E)4.fm
00/12/18
Refere
nc
es
- T
roub
le
shoot
ing Cha
rt -
Troubleshooting Chart
Many potential "problems" can be resolved by the owner without calling a service
technician.
If something is wrong with this product, check the following before calling your author-
ised SHARP dealer or service centre.
technician.
If something is wrong with this product, check the following before calling your author-
ised SHARP dealer or service centre.
„
General
„
CD player
„
Tuner
„
Remote control
„
Condensation
Symptom
Possible cause
z
The clock is not on time.
z
Did a power failure occur? Reset the
clock. (Refer to page 15.)
clock. (Refer to page 15.)
z
When a button is pressed, the unit
does not respond.
does not respond.
z
Set this unit to the power stand-by mode
and then turn it back on.
and then turn it back on.
z
If the unit still malfunctions, reset it. (Refer
to step 3 under "If trouble occurs" on page
34.)
to step 3 under "If trouble occurs" on page
34.)
z
No sound is heard.
z
Is the volume level set to "0"?
z
Are the headphones connected?
z
Are the speaker wires disconnected?
Symptom
Possible cause
z
Playback does not start.
z
Is the disc loaded upside-down?
z
Playback stops in the middle or is
not performed properly.
not performed properly.
z
Does the disc satisfy the standards?
z
Is the disc distorted or scratched?
z
Playback sounds are skipped, or
stopped in the middle of a track.
stopped in the middle of a track.
z
Is the unit located near excessive vibra-
tions?
tions?
z
Is the disc very dirty?
z
Has condensation formed inside the unit?
Symptom
Possible cause
z
Radio makes unusual noise con-
secutively.
secutively.
z
Is the unit placed near the TV or compu-
ter?
ter?
z
Is the FM/AM loop aerial placed properly?
Move the AC power lead away from the
aerial if located near.
Move the AC power lead away from the
aerial if located near.
Symptom
Possible cause
z
The remote control does not oper-
ate.
ate.
z
Is the AC power lead of the unit plugged
in?
in?
z
Is the battery polarity respected?
z
Are the batteries dead?
z
Is the distance or angle incorrect?
z
Does the remote control sensor receive
strong light?
strong light?
Sudden temperature changes, storage or op-
eration in an extremely humid environment
may cause condensation inside the cabinet
(CD pickup, etc.) or on the transmitter on the
remote control.
Condensation can cause the unit to malfunc-
tion. If this happens, leave the power on with
no disc in the unit until normal playback is pos-
sible (about 1 hour). Wipe off any condensa-
tion on the transmitter with a soft cloth before
operating the unit.
eration in an extremely humid environment
may cause condensation inside the cabinet
(CD pickup, etc.) or on the transmitter on the
remote control.
Condensation can cause the unit to malfunc-
tion. If this happens, leave the power on with
no disc in the unit until normal playback is pos-
sible (about 1 hour). Wipe off any condensa-
tion on the transmitter with a soft cloth before
operating the unit.
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
34
XL-3000H(E)4.fm
00/12/18
Refere
nc
es
- T
roub
le
shoot
ing C
h
a
rt / M
a
intenanc
e -
Troubleshooting Chart (continued)
„
If trouble occurs
When this product is subjected to strong external interference (mechanical shock,
excessive static electricity, abnormal supply voltage due to lightning, etc.) or if it is
operated incorrectly, it may malfunction.
excessive static electricity, abnormal supply voltage due to lightning, etc.) or if it is
operated incorrectly, it may malfunction.
If such a problem occurs, do the following:
Caution:
This operation will erase all data stored in memory including clock, timer settings,
tuner preset, and CD programme.
tuner preset, and CD programme.
„
Before transporting the unit
Press the FUNCTION button until "CD STOP" appears on the display and remove a
CD from the unit. Your unit checks whether there is a disc inside the unit when the
compartment is closed. "NO DISC" appears if no disc is left. Then, set the unit to the
power stand-by mode.
CD from the unit. Your unit checks whether there is a disc inside the unit when the
compartment is closed. "NO DISC" appears if no disc is left. Then, set the unit to the
power stand-by mode.
Maintenance
„
Cleaning the CD pickup lens
Do not touch the laser pickup lens. If fingerprints or dust accumulate on the pickup,
clean it gently with a dry cotton swab.
clean it gently with a dry cotton swab.
„
Cleaning the cabinet
1
Set the unit to the stand-by mode and turn the power on again.
2
If the unit is not restored in step 1, unplug and plug in the unit, and then turn
the power on.
the power on.
3
If neither step 1 nor 2 restores the unit, do the following:
Press the ON/STAND-BY button to enter the power stand-by mode.
Unplug the AC power lead from the AC INPUT socket on the unit.
Whilst pressing down the MEMORY/SET button and the
Unplug the AC power lead from the AC INPUT socket on the unit.
Whilst pressing down the MEMORY/SET button and the
button, plug the
AC power lead into the AC INPUT socket on the unit.
AC INPUT
Periodically wipe the cabinet with a soft cloth and a di-
luted soap solution, then with a dry cloth.
luted soap solution, then with a dry cloth.
Caution:
z
Do not use chemicals for cleaning (petrol, paint thin-
ner, etc.). It may damage the cabinet finish.
ner, etc.). It may damage the cabinet finish.
z
Do not apply oil to the inside of the unit. It may cause
malfunctions.
malfunctions.
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
35
XL-3000H(E)4.fm
00/12/18
Refere
nc
es
- Spe
c
ific
a
tion
s
-
Specifications
As part of our policy of continuous improvement, SHARP reserves the right to make
design and specification changes for product improvement without prior notice. The
performance specification figures indicated are nominal values of production units.
There may be some deviations from these values in individual units.
design and specification changes for product improvement without prior notice. The
performance specification figures indicated are nominal values of production units.
There may be some deviations from these values in individual units.
„
General
„
Amplifier
„
CD player
„
Tuner
„
Speaker
Power source
AC 230 V, 50 Hz
Power consumption
Power on: 40 W
Power stand-by: 0.6 W
Dimensions
Width: 230 mm (9-1/16")
Height: 128 mm (5-1/16")
Depth: 293 mm (11-9/16")
Height: 128 mm (5-1/16")
Depth: 293 mm (11-9/16")
Weight
3.0 kg (6.6 lbs.)
Output power
RMS: 40 W (20 W + 20 W) (10 % T.H.D.)
Output terminals
Speakers: 6 ohms
Headphones: 16 - 50 ohms (recommended: 32 ohms)
CD digital output (optical)
Input terminals
Video/Auxiliary (audio signal): 500 mV/47 kohms
Type
Compact disc player
Signal readout
Non-contact, 3-beam semiconductor laser pickup
D/A converter
1-bit D/A converter
Frequency response
20 - 20,000 Hz
Dynamic range
90 dB (1 kHz)
Frequency range
FM: 87.5 - 108 MHz
AM: 522 - 1,620 kHz
Type
2-way type speaker system
5 cm (2") Tweeter
10 cm (4") Woofer
Maximum input power
40 W
Rated input power
20 W
Impedance
6 ohms
Dimensions
Width: 140 mm (5-9/16")
Height: 288 mm (11-3/8")
Depth: 187 mm (7-3/8")
Height: 288 mm (11-3/8")
Depth: 187 mm (7-3/8")
Weight
2.0 kg (4.4 lbs.)/each
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
TINSE0058SJZZ
B0102.HK
B0102.HK
TERMS OF GUARANTEE
Sharp Electronics (UK) Ltd. (“Sharp”) guarantees to provide for the repair, or at its option the replace-
ment, of this product subject to the conditions listed below:-
ment, of this product subject to the conditions listed below:-
1. This guarantee shall only apply to faults which are due to inferior workmanship or materials. It does
not cover faults or damage caused by accident, misuse, fair wear and tear, neglect, tampering with
the product, or repair other than by a Service Facility appointed by Sharp.
the product, or repair other than by a Service Facility appointed by Sharp.
2. As this product is intended for private domestic use only, the guarantee will not apply if the product
is used in the course of a business, trade or profession.
3. To benefit from this guarantee, any fault which occurs must be notified to Sharp, or its appointed
Service Facility within one year from the date this product was purchased. Proof of purchase must
be provided.
be provided.
4. The guarantee does not cover carriage costs, jewelled styli, audio tapes, compact discs or batter-
ies.
5. In the unlikely event of this product requiring repair, please contact the supplier from whom it was
purchased. Where this is not possible, please contact the Sharp Customer Information Centre on
the telephone number given below.
the telephone number given below.
6. No person has any authority to vary the terms or conditions of this guarantee.
7. This guarantee is offered as an additional benefit to your statutory rights, and does not affect these
rights in any way.
If you have any difficulty operating this product, or would like information on other Sharp products,
please telephone the Sharp Customer Information Centre on the number given below.
please telephone the Sharp Customer Information Centre on the number given below.
Sharp Customer Information Centre - Telephone 08705 274277
0008
SHARP ELECTRONICS (U.K.) LTD.
Sharp House, Thorp Road, Newton Heath, Manchester, M40 5BE
SHARP CORPORATION
9906
XL3000H(BACK)
2001.6.6, 11:12 AM
1
