DOWNLOAD Sharp CD-SW300H Service Manual ↓ Size: 4.15 MB | Pages: 48 in PDF or view online for FREE

13/2/06

CD-SW300HE_EN.fm

CD-SW300H

TINSZA165AWZZ

1

2

3

4

5

6

7

When this product is subjected to strong external interference (me-
chanical shock, excessive static electricity, abnormal supply voltage
due to lightning, etc.) or if it is operated incorrectly, it may malfunc-
tion.

If such a problem occurs, do the following:
1

Set the unit to the stand-by mode and turn the power on again.

2

If the unit is not restored in the previous operation, unplug and
plug in the unit, and then turn the power on.

Note:
If neither operation above restores the unit, clear all the memory by
resetting it.

1

Press the ON/STAND-BY button to enter the power stand-by
mode.

2

Whilst pressing down the   button and the   button, press the
TUNER (BAND) button until "CLEAR ALL" appears.

Caution:
This operation will erase all data stored in memory including clock,
timer settings, tuner preset, and CD programme.

Remove all CDs from the unit. Make sure there is no CD in the disc
tray. Then, set the unit to the power stand-by mode. Carrying the unit
with discs left inside can damage the unit.

Compact discs are fairly resistant to damage, however mistracking
can occur due to an accumulation of dirt on the disc surface. Follow
the guidelines below for maximum enjoyment from your CD collec-
tion and player.

Do not write on either side of the disc, particularly the non-label
side from which signals are read. Do not mark this surface.
Keep your discs away from direct sunlight, heat, and excessive
moisture.
Always hold the CDs by the edges. Fingerprints, dirt, or water on
the CDs can cause noise or mistracking. If a CD is dirty or does
not play properly, clean it with a soft, dry cloth, wiping straight out
from the centre, along the radius.

 

13/2/06

CD-SW300HE_EN.fm

CD-SW300H

TINSZA165AWZZ

Dirty heads, capstans or pinch rollers can cause poor sound and
tape jams. Clean these parts with a cotton swab moistened with
commercial head/pinch roller cleaner or isopropyl alcohol.
When cleaning the heads, pinch rollers, etc., unplug the unit which
contains high voltages.

After long use, the deck's heads and capstans may become mag-
netised, causing poor sound. Demagnetise these parts once ev-
ery 30 hours of playing/recording time by using a commercial tape
head demagnetiser. Read the demagnetiser's instructions care-
fully before use.

Poor performance during CD playback (skipping or jumping) can be
caused by a dirty or contaminated CD laser pick up lens. If this
happens then the use of a commercially available CD lens cleaning
discs may restore normal operation. Contact your supplier or local
CD software dealer to obtain CD lens cleaning discs. Ensure all
included instructions/documentation are carefully followed.

Periodically wipe the cabinet with a soft cloth and a diluted soap so-
lution, then with a dry cloth.
Caution:

Do not use chemicals for cleaning (petrol, paint thinner, etc.). It
may damage the cabinet finish.
Do not apply oil to the inside of the unit. It may cause malfunc-
tions.

As part of our policy of continuous improvement, SHARP reserves
the right to make design and specification changes for product im-
provement without prior notice. The performance specification fig-
ures indicated are nominal values of production units. There may be
some deviations from these values in individual units.

* This power consumption value is obtained when the demonstration

mode is cancelled in the power stand-by mode. Refer to page 12 to
cancel the demonstration mode.

 

Playback head

Erase head

Capstans

Recording/Playback head

Pinch rollers

TAPE 1

TAPE 2

A

C

B

C

D

E

B

AC 230 - 240 V, 50 Hz

Power consumption Power on: 225 W

Power stand-by: 0.6 W (*)

Width: 260 mm (10-1/4")  
Height: 330 mm (13") 
Depth: 323 mm (12-7/8")

10 kg (22 lbs.)

Front Speaker:
RMS: 200 W (100 W + 100 W) (10% T.H.D)
RMS: 156 W (78 W + 78 W) (0.9% T.H.D)

Subwoofer:
RMS: 200 W (DIN 45 324)
RMS: 166 W (DIN 45 500)

Front Speakers: 6 ohms
Subwoofer: 12 ohms
Headphones: 16 - 50 ohms 
(recommended: 32 ohms)
Video output: 1Vp-p

Game/ Auxiliary (audio signal): 
500 mV/ 47 k ohms
Game/Video: 1Vp-p

13/2/06

CD-SW300HE_EN.fm

CD-SW300H

TINSZA165AWZZ

1

2

3

4

5

6

7

 

 

5-disc multi-play compact disc player

Non-contact, 3-beam semiconductor laser 
pickup

1-bit D/A converter

20 - 20,000 Hz

90 dB (1 kHz)

FM: 87.5 - 108.0 MHz

AM: 522 - 1,620 kHz

50 - 14,000 Hz (normal tape)

55 dB (TAPE 1, playback) 
50 dB (TAPE 2, recording/playback)

0.3% (WRMS)

3-way type speaker system 
Super tweeter
5 cm (2") tweeter
16 cm (6-5/16") woofer

200 W

100 W

6 ohms

Width: 200 mm (7-7/8") 
Height: 330 mm (13") 
Depth: 231 mm (9-1/8")

3.3 kg (7.3 lbs.) /each

Full Range 
20 cm (8") subwoofer

400 W

200 W

12 ohms

Width: 250 mm (9-13/16") 
Height: 330 mm (13") 
Depth: 294 mm (11-9/16")

5.9 kg (13 lbs.)

04/12/15

CD_SW300HE_BACK.fm

TINSEA137AWZZ 
06C R KI   1

Sharp House, Thorp Road, Newton Heath, Manchester, M40 5BE

Sharp Electronics (UK) Ltd. (“Sharp”) guarantees to provide for the repair, or at its option the replace-
ment, of this product subject to the conditions listed below:-

1. This guarantee shall only apply to faults which are due to inferior workmanship or materials. It does

not cover faults or damage caused by accident, misuse, fair wear and tear, neglect, tampering with
the product, or repair other than by a Service Facility appointed by Sharp.

2. As this product is intended for private domestic use only, the guarantee will not apply if the product

is used in the course of a business, trade or profession.

3. To benefit from this guarantee, any fault which occurs must be notified to Sharp, or its appointed

Service Facility within one year from the date this product was purchased. Proof of purchase must
be provided.

4. The guarantee does not cover carriage costs, audio tapes, compact discs or batteries.

5. In the unlikely event of this product requiring repair, please contact the supplier from whom it was

purchased. Where this is not possible, please contact the Sharp Customer Information Centre on
the telephone number given below.

6. No person has any authority to vary the terms or conditions of this guarantee.

7. This guarantee is offered as an additional benefit to your statutory rights, and does not affect these

rights in any way.

If you have any difficulty operating this product, or would like information on other Sharp products,
please telephone the Sharp Customer Information Centre on the number given below.

Sharp Customer Information Centre - Telephone 08705 274277

(or (01) 676 0648 if telephoning from Ireland)