Sharp CD-MPS660H (serv.man11) User Manual / Operation Manual ▷ View online
03/12/19
CD-MPS660H(H)E4.fm
E-38
ENGLISH
8
CD-MPS660H
TINSZA035AWZZ
Advanc
e
d Featu
res
"
Sleep operation
The radio, CD, MP3 disc and cassette tape can all be turned off
automatically.
automatically.
To confirm the remaining sleep time:
To cancel the sleep operation:
Press the ON/STAND-BY button whilst "SLEEP" is indicated.
To cancel the sleep operation without setting the system to the
stand-by mode, proceed as follows.
Press the ON/STAND-BY button whilst "SLEEP" is indicated.
To cancel the sleep operation without setting the system to the
stand-by mode, proceed as follows.
"
To use timer and sleep operation together
Sleep and timer playback:
For example, you can fall asleep listening to the radio and wake up
to CD in the next morning.
For example, you can fall asleep listening to the radio and wake up
to CD in the next morning.
Sleep and timer recording:
For example, you can fall asleep listening to the CD and record
radio programmes whilst sleeping.
For example, you can fall asleep listening to the CD and record
radio programmes whilst sleeping.
Caution:
When using the cassette deck, be sure the tape length is long
enough to perform both functions. If you want to sleep and wake up
listening to a tape, and the length of the tape is shorter than the
sleep timer setting, timer playback or recording will not be possible.
When using the cassette deck, be sure the tape length is long
enough to perform both functions. If you want to sleep and wake up
listening to a tape, and the length of the tape is shorter than the
sleep timer setting, timer playback or recording will not be possible.
1
Play back the desired sound source.
2
Press the CLOCK/TIMER button.
3
Within 10 seconds, press the
or
button
to
select
"SLEEP", and press the MEMO-
RY/SET button.
RY/SET button.
4
Press the
or
button to select the time.
(Maximum: 3 hours - Minimum: 1 minute)
!
3 hours - 5 minutes 5-minute intervals
!
5 minutes - 1 minute 1-minute intervals
5
Press the MEMORY/SET but-
ton.
ton.
"SLEEP" will appear.
6
The unit will enter the power stand-by mode automatically
after the preset time has elapsed.
after the preset time has elapsed.
The volume will be turned down 1 minute before the sleep op-
eration finishes.
eration finishes.
1
Whilst "SLEEP" is indicated, press the CLOCK/TIMER button.
2
Within 10 seconds, press the
or
button to select
"SLEEP X : XX".
"X : XX" is remaining sleep time.
"X : XX" is remaining sleep time.
!
The remaining sleep time is displayed for about 10 seconds.
!
You can change the remaining sleep time whilst it is displayed by
pressing the MEMORY/SET button.
pressing the MEMORY/SET button.
1
Whilst "SLEEP" is indicated, press the CLOCK/TIMER button.
2
Within 10 seconds, press the
or
button to select
"SLEEP OFF", and press the MEMORY/SET button.
1
Set the sleep time (see left, steps 1 - 5).
2
Whilst the sleep timer is set, set the timer playback or recording
(steps 2 - 10, pages 35 - 36).
(steps 2 - 10, pages 35 - 36).
Sleep timer setting
Timer playback or
recording setting
recording setting
Sleep operation will
automatically stop.
automatically stop.
Timer playback or recording
start time
start time
End time
1 minute - 3 hours
Desired time
03/12/19
CD-MPS660H(H)E4.fm
E-39
ENGLISH
CD-MPS660H
TINSZA035AWZZ
Advanc
e
d Featu
res
Enhancing your system
The connection lead is not included. Purchase a commercially avail-
able lead as shown below.
able lead as shown below.
"
Listening to sounds of game, VCR, DVD, etc.
Note:
To prevent noise interference, place the unit away from the televi-
sion.
To prevent noise interference, place the unit away from the televi-
sion.
Auto power on function:
When you press any of the following buttons, the unit turns on.
When you press any of the following buttons, the unit turns on.
!
GAME/VIDEO button (main unit and remote control): The unit
turns on and the "GAME" function is activated.
turns on and the "GAME" function is activated.
!
/ button (main unit and remote control): The unit turns on
and playback of the last function starts (CD/TAPE/TUNER/
GAME).
GAME).
"
To record sounds of game, VCR, etc.
Game system, VCR,
DVD player, etc.
DVD player, etc.
Red
White
Yellow
Yellow
To the line output sockets
To video
input socket
input socket
RCA lead
(not supplied)
(not supplied)
Video cable
(not supplied)
(not supplied)
Video cable
(not supplied)
(not supplied)
Yellow
TV
Yellow
Red
White
1
Connect a video game system, VCR, DVD, etc. to the front
GAME INPUT (VIDEO, AUDIO L and R) sockets.
GAME INPUT (VIDEO, AUDIO L and R) sockets.
2
Connect a TV to the rear VIDEO OUT socket.
Switch the TV input to auxiliary.
3
Press the ON/STAND-BY button to turn the power on.
4
Press the GAME/VIDEO button.
5
Play the connected equipment.
You can enjoy sounds from the supplied speakers and images
on the TV.
on the TV.
1
Insert a cassette in the TAPE 2 cassette compartment.
2
Press the GAME/VIDEO button.
3
Press the
button.
4
Press the / button.
5
Start the game system, VCR, etc.
03/12/19
CD-MPS660H(H)E4.fm
E-40
ENGLISH
8
CD-MPS660H
TINSZA035AWZZ
Refe
rences
"
Headphones
!
Before plugging in or unplugging the headphones, reduce the
volume.
volume.
!
Be sure your headphones have a 3.5 mm (1/8") diameter plug
and are between 16 ohms and 50 ohms impedance. The recom-
mended impedance is 32 ohms.
and are between 16 ohms and 50 ohms impedance. The recom-
mended impedance is 32 ohms.
!
Plugging in the headphones disconnects the speakers automati-
cally. Adjust the volume using the VOLUME control.
cally. Adjust the volume using the VOLUME control.
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
ing a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
"
General
"
CD player
Symptom
Possible cause
!
The clock is not set to the
correct time.
correct time.
!
Did a power failure occur? Reset
the clock. (Refer to page 12.)
the clock. (Refer to page 12.)
!
When a button is pressed,
the unit does not respond.
the unit does not respond.
!
Set the unit to the power stand-
by mode and then turn it back on.
by mode and then turn it back on.
!
If the unit still malfunctions, reset
it. (Refer to page 42.)
it. (Refer to page 42.)
!
No sound is heard.
!
Is the volume level set to "0"?
!
Are the headphones connected?
!
Are the speaker wires discon-
nected?
nected?
Symptom
Possible cause
!
Playback does not start.
!
Is the disc loaded upside down?
!
Playback stops in the mid-
dle or is not performed
properly.
dle or is not performed
properly.
!
Does the disc satisfy the stan-
dards?
dards?
!
Is the disc distorted or
scratched?
scratched?
!
Playback sounds are
skipped, or stopped in the
middle of a track.
skipped, or stopped in the
middle of a track.
!
Is the unit located near excessive
vibrations?
vibrations?
!
Is the disc very dirty?
!
Has condensation formed inside
the unit?
the unit?
03/12/19
CD-MPS660H(H)E4.fm
E-41
ENGLISH
CD-MPS660H
TINSZA035AWZZ
Refe
rences
Troubleshooting chart (continued)
!
Cassette deck
!
Remote control
!
Tuner
!
Condensation
Sudden temperature changes, storage or operation in an extremely
humid environment may cause condensation inside the cabinet (CD
pickup, tape heads, etc.) or on the transmitter on the remote control.
Condensation can cause the unit to malfunction. If this happens,
leave the power on with no disc (or cassette) in the unit until normal
playback is possible (about 1 hour). Wipe off any condensation on
the transmitter with a soft cloth before operating the unit.
humid environment may cause condensation inside the cabinet (CD
pickup, tape heads, etc.) or on the transmitter on the remote control.
Condensation can cause the unit to malfunction. If this happens,
leave the power on with no disc (or cassette) in the unit until normal
playback is possible (about 1 hour). Wipe off any condensation on
the transmitter with a soft cloth before operating the unit.
Symptom
Possible cause
"
Cannot record.
"
Is the erase-prevention tab re-
moved?
moved?
"
Cannot record tracks with
proper sound quality.
proper sound quality.
"
Is it a normal tape? (You cannot
record on a metal or CrO tape.)
record on a metal or CrO tape.)
"
Cannot erase completely.
"
Sound skipping.
"
Is there slack in the tape?
"
Is the tape stretched?
"
Cannot hear treble.
"
Are the capstans, pinch rollers,
or heads dirty?
or heads dirty?
"
Sound fluctuation.
"
Cannot remove the tape.
"
If a power failure occurs during
playback, the heads remain en-
gaged with the tape. Do not open
the compartment with great
force.
playback, the heads remain en-
gaged with the tape. Do not open
the compartment with great
force.
Symptom
Possible cause
"
The remote control does
not operate.
not operate.
"
Is the AC power lead of the unit
plugged in?
plugged in?
"
Is the battery polarity correct?
"
Are the batteries dead?
"
Is the distance or angle incor-
rect?
rect?
"
Does the remote control sensor
receive strong light?
receive strong light?
Symptom
Possible cause
"
The radio makes unusual
noises continuously.
noises continuously.
"
Is the unit placed near the TV or
computer?
computer?
"
Is the FM aerial or AM loop aerial
placed properly? Move the aerial
away from the AC power lead if
it's located nearby.
placed properly? Move the aerial
away from the AC power lead if
it's located nearby.
Click on the first or last page to see other CD-MPS660H (serv.man11) service manuals if exist.