Panasonic TX-LR22X20 Service Manual ▷ View online
TX-LR22X20
13
6.2.
Power LED Blinking timing chart
1. Subject
Information of LED Flashing timing chart.
2. Contents
When an abnormality occurs, the protection circuit will operate and reset the unit to stand by mode. During this time, the
defective block can be identified by the number of blinking times of the Power LED on the front panel of the unit as follow:
defective block can be identified by the number of blinking times of the Power LED on the front panel of the unit as follow:
6.3.
No Power
First check point
There are following 2 states of No Power indication by power LED.
There are following 2 states of No Power indication by power LED.
1. No lit
2. Red is lit then turns red blinking a few seconds later. (See 6.2.)
2. Red is lit then turns red blinking a few seconds later. (See 6.2.)
Blinking times
Contents
BOARD
1
Inverter_SOS
IP BOARD
3
SOS
A BOARD
4
DTV_9V
IP/A BOARD
5
MAIN_9V
A BOARD
6
SUB_5V
A BOARD
7
SUB 3.3V
A BOARD
8
MAIN_3.3V
A BOARD
9
SOUND_SOS
A BOARD
10
HQ1L_SOS/ZWEI_SOS
A BOARD
13
EMERGENCY SOS
A BOARD
14
Audio PWM SOS
A BOARD
TX-LR22X20
14
7 Disassembly and Assembly Instructions
7.1.
AC Cord Dressing
Insert beads 3 pcs. And slide down to lower hole.
TX-LR22X20
15
7.2.
AC Cord Bracket Installation
1. Put on the AC CORD BRACKET on the CABINET.
2. Fix the AC CORD BRACKET with SCREW.
3. Insert AC CORD connector into IP-PCB connector.
4. Clamp the AC CORD.
5. Insert AC CORD bushing into the AC CORD BRACKET.
6. AC CORD is pushed into the bottom of the bracket.
2. Fix the AC CORD BRACKET with SCREW.
3. Insert AC CORD connector into IP-PCB connector.
4. Clamp the AC CORD.
5. Insert AC CORD bushing into the AC CORD BRACKET.
6. AC CORD is pushed into the bottom of the bracket.
TX-LR22X20
16
7.3.
Screw Fixing
1. Fix VESA METAL at SET.
2. Fix SCREWS at VESA METAL and A-BOARD.
2. Fix SCREWS at VESA METAL and A-BOARD.
Click on the first or last page to see other TX-LR22X20 service manuals if exist.