Panasonic TX-L47FT60B / TX-LR47FT60 Service Manual ▷ View online
Applicable Signals
Applicable input signal for PC is basically compatible to HDMI standard timing.
Signal name
Horizontal frequency (kHz)
Vertical frequency (Hz)
640
480 @60 Hz
31.47 60.00
1,280
720 @60 Hz
45.00 60.00
1,920
1,080 @60Hz
67.50 60.00
Note:
Signals other than above may not be displayed properly.
The above signals are reformatted for optimal viewing on your display.
PC signal is magnified or compressed for display, so that it may not be possible to show fine detail
with sufficient clarity.
Signal name
COMPONENT
HDMI
525 (480) / 60i,60p
*
*
625 (576) / 50i, 50p
*
*
750 (720) / 60p, 50p
*
*
1,125 (1,080) / 60i, 50i
*
*
1,125 (1,080) / 60p
*
1,125 (1,080) / 50p
*
1,125 (1,080) / 24p
*
PC
(from HDMI terminal)
Component
(Y, Pb, Pr) (from AV2 terminal), HDMI
8
Specifications
Power
Source:
220-240V AC, 50 / 60Hz
Rated Power Consumption:
132W
Stand-by Power Consumption:
0.20W
Aerial Impedance:
75
unbalanced, Coaxial Type
Receiving System:
L47FT60B (UK)
DVB-S/S2 Freesat services via Satelite dish input
(freesat Other Sat.)
Receiver frequency range:950MHz to2,150MHz
Not available for DiSEqC control
DVB-T/T2 Digital terrestrial services
PAL I UHF E21-E68
PAL 525/60 (AV only)
M.NTSC (AV only)
NTSC (AV only)
L47FT60B (Ireland)
DVB-S/S2 Receiver frequency range:950MHz to2,150MHz
Not available for DiSEqC control
DVB-T Digital terrestrial services
PAL I VHF A-J
UHF E21-E69
CATV S1-S20
CATV S21-S41(Hyperband)
PAL 525/60 (AV only)
M.NTSC (AV only)
NTSC (AV only)
LR47FT60
DVB-S/S2 Digital satellite services (
MPEG2 and MPEG4-AVC(H.264)
)
Receiver frequency range:950MHz to2,150MHz
DiSEqC – Version 1.0
DVB-T /T2 Digital terrestrial services (
MPEG2 and MPEG4-AVC(H.264)
)
DVB-C Digital cable services (
MPEG2 and MPEG4-AVC(H.264)
)
PAL D/K,
SECAM
D/K
VHF R1-R2 VHF R3-R5
VHF R6-R12 UHF E21-E69
PAL 525/60 (AV only)
M.NTSC (AV only)
NTSC (AV only)
Satellite dish input:
Female F-type 75
Aerial - Rear:
L47FT60B (UK) L47FT60B (Ireland) / LR47FT60
UHF VHF/UHF
Operating Conditions:
Temperature: 0°C
35°C
Humidity:
20%
80% RH (non condensing)
Terminals:
AV1 IN
Video (21 pin)
1V p-p 75
Audio (21 pin)
500mV rms 10k
RGB (21 pin)
0.7V p-p 75
AV1 OUT
Video (21 pin)
1V p-p 75
Audio (21 pin)
500mV rms 1k
AV2 IN
Video (RCAx1)
1V p-p 75
(COMPONENT/VIDEO)
Audio (RCAx2)
500mV rms 10k
(used for HDMI_ AV2 audio IN)
Video (RCAx3)
Y:1V p-p 75
(including synchronization)
Pb, Pr: ±0.35V p-p 75
HDMI1, HDMI2, HDMI3
Type A Connectors
HDMI
1/3 : 3D, Content Type, Deep Colour
HDMI 2 : 3D, Content Type, Audio Return Channel, Deep Colour
This TV supports “HDAVI Control 5” function.
9
DIGITAL AUDIO OUT
PCM / Dolby digital / DTS, Fiber optic
USB 1/2/3
USB1/2: USB 2.0 DC 5V Max 500mA
USB3 : USB 3.0 DC 5V Max 900mA
ETHERNET
RJ45, IEEE802.3 10BASE-T / 100BASE-TX
CARD SLOT
SD Card slot x1
Common interface slot (Complies with CI+) x 1
Wireless LAN:
Standard Compliance
IEEE802.11a/n , IEEE802.11b/g/n
Frequency Range
IEEE802.11a/n: 5.180 GHz – 5.320 GHz
5.500 GHz – 5.580 GHz
5.660 GHz – 5.700 GHz
IEEE802.11b/g/n: 2.412 GHz – 2.472 GHz
Security
WPA2-PSK
(TKIP/AES)
WPA-PSK
(TKIP/AES)
WEP(64
bit/128
bit)
3D
Eyewear:
Dimensions (W x H x D)
165mm x 38m x 166mm
Mass
18g
Lens Type
Circularly-polarised filter
Usage Temperature Range
0°C
40°C
Materials
Main body / Lens section: Resin
LCD screen:
L5EDDYY00464
1920 x 1080, 16:9
Visible Diagonal 1190mm
Speaker:
8 train speakers x 2, Woofer (Ø 75mm) x 1
Audio
Output:
18W (4W + 4W + 10W)
Headphones:
3.5mm,
8
Impedance
Accessories supplied :
Remote Control
3D
Glasses
2 x R6 (UM3) Batteries
SCART
Cable
Dimensions:
Width:
Height: Depth:
Including TV stand
1,067mm 713mm 261mm
TV set only
1,067mm 627mm 35mm
Mass:
Including TV stand
19.0kg
TV set only
15.0kg
Design and Specifications are subject to change without notice. Mass and dimensions shown are approximate.
This equipment complies with the EMC standards listed below:
EN55013, EN61000-3-2, EN61000-3-3, EN55020, EN55022, EN55024
10
Technical Description
Specification of KEY for CI Plus, DTCP-IP, One-to-One, Netflix, Widewine and HDCP
General information:
General information:
1. NAND FLASH (IC8900) for spare parts has the seed of KEY for each.
2. The final KEY data will be generated by Pro4 IC (IC8000) when SELF CHECK was done and are stored in both
Pro4 IC (IC8000) and NAND FLASH (IC8900).
All KEYs are not generated for all models.
The necessary KEY are only generated and stored depend on the feature of models.
2. The final KEY data will be generated by Pro4 IC (IC8000) when SELF CHECK was done and are stored in both
Pro4 IC (IC8000) and NAND FLASH (IC8900).
All KEYs are not generated for all models.
The necessary KEY are only generated and stored depend on the feature of models.
Replacement of ICs:
When Pro4 IC (IC8000) is replaced, NAND FLASH (IC8900) should be also replaced with new one the same time.
When NAND FLASH (IC8900) is replaced, Pro4 IC (IC8000) is not necessary to be replaced the same time.
After the replacement of IC, SELF CHECK should be done to generate the final KEY data.
How to SELF CHECK: While pressing [VOLUME ( - )] button on the main unit, press the MENU button on the remote
control for more than 3 seconds.
TV will be forced to the factory shipment setting after this SELF CHECK.
When NAND FLASH (IC8900) is replaced, Pro4 IC (IC8000) is not necessary to be replaced the same time.
After the replacement of IC, SELF CHECK should be done to generate the final KEY data.
How to SELF CHECK: While pressing [VOLUME ( - )] button on the main unit, press the MENU button on the remote
control for more than 3 seconds.
TV will be forced to the factory shipment setting after this SELF CHECK.
Model and Keys:
USB HDD Recording:
General information:
General information:
Digital TV programmes can be recorded in USB HDD.
A One-to-One key generated in A-board by SELF CHECK binds TV and USB-HDD for communication.
That key is only one key for them. If the key is difference, TV can not access USB-HDD.
Caution:
New key will be generated by following SELF CHECK and previous TV programmes recorded in USB HDD will not be
viewed.
SELF CHECK: While pressing [VOLUME ( - )] button on the main unit, press the MENU button on the remote control for more
than 3 seconds.
A One-to-One key generated in A-board by SELF CHECK binds TV and USB-HDD for communication.
That key is only one key for them. If the key is difference, TV can not access USB-HDD.
Caution:
New key will be generated by following SELF CHECK and previous TV programmes recorded in USB HDD will not be
viewed.
SELF CHECK: While pressing [VOLUME ( - )] button on the main unit, press the MENU button on the remote control for more
than 3 seconds.
Keys
Model No.
CI PLUS
DTCP-IP
One-to-One
(for USB Rec.)
Netflix
Widewine
HDCP
TX-L47FT60B Yes
Yes Yes Yes Yes
TX-LR47FT60 Yes
None Yes Yes Yes
11
Click on the first or last page to see other TX-L47FT60B / TX-LR47FT60 service manuals if exist.