Panasonic TX-29P20T Service Manual ▷ View online
11 Schematic Diagram for models TC-15PM10R (MX-7
Chassis)
IMPORTANT SAFETY NOTICE Components identified by
mark have special characteristics important for safety.
When replacing any of these components, use only
manufacturer’s specified parts.
mark have special characteristics important for safety.
When replacing any of these components, use only
manufacturer’s specified parts.
Notes:
1. Resistor
All resistors are carbon 1.4W resistors unless marked as follows:
Unit of resistance is OHM (
Ω
) (K=1 000 M=1 000 000)
Nonflammable
Metal Oxide
Solid
Metal Film
Wire Wound
Fuse
2. Capacitor
All capacitors are ceramic 50V capacitors unless marked as follows:
Unit of capacitance is µF, unless otherwise noted.
Temperature
Compensation
Compensation
Electrolytic
Polyester
Bipolar
Metalized
Polyester
Polyester
Dipped
Tantalum
Tantalum
Polypropylene
Z-Type
3. Coil
Unit of inductance is µH, unless otherwise noted.
Unit of resistance is OHM (
Ω
) (K=1 000 M=1 000 000)
4. Test Point
: Test Point position
5. Earth Symbol
: Chassis Earth (Cold)
: Line Earth (Hot)
6. Voltage Measurement
Voltage is measured using a DC voltmeter.
Conditions of the measurement are the following:
Power Source..........................AC 220V, 50Hz
Receiving Signal.....................Colour Bar signal (RF)
All customer’s controls............Maximum positions
Conditions of the measurement are the following:
Power Source..........................AC 220V, 50Hz
Receiving Signal.....................Colour Bar signal (RF)
All customer’s controls............Maximum positions
7. Number in red circle indicates waveform number.
(See waveform pattern table)
8. When arrow mark (
) is found, connection is easily found from the direction of arrow.
9.
: Indicates the major signal flow.
10. This schematic diagram is the latest at the time of printing and subject to change without notice.
Remarks:
1. The Power Circuit contains a circuit area which uses a separate power supply to isolate the earth connection. The circuit is
defined by HOT and COLD indications in the schematic diagram. Take the following precautions:
All circuits except the Power Circuit are cold.
Precautions:
All circuits except the Power Circuit are cold.
Precautions:
a
Do not touch the hot part or the hot and cold parts at the same time or you may be
shocked
shocked
b
Do not short-circuit the hot and cold circuits or a fuse may blow and parts may break
c
Do not connect an instrument such as an oscilloscope to the hot and cold circuits
simultaneously or a fuse may blow. Connect the earth of instruments to the earth
connection of the circuit being measured.
simultaneously or a fuse may blow. Connect the earth of instruments to the earth
connection of the circuit being measured.
d
Make sure to disconnect the power plug before removing the chassis.
18
TX-29P20T
Click on the first or last page to see other TX-29P20T service manuals if exist.