Panasonic KX-TG6521CAB / KX-TG6521CAT / KX-TG6522CAT / KX-TGA651RUB / KX-TGA651RUT Service Manual ▷ View online
46
KX-TG6521CAB/KX-TG6521CAT/KX-TG6522CAT/KX-TGA651RUB/KX-TGA651RUT
10.1.2. Handset
47
KX-TG6521CAB/KX-TG6521CAT/KX-TG6522CAT/KX-TGA651RUB/KX-TGA651RUT
10.1.3. Charger Unit
48
KX-TG6521CAB/KX-TG6521CAT/KX-TG6522CAT/KX-TGA651RUB/KX-TGA651RUT
10.2. How to Replace the Handset LCD
Note:
The illustrations are simplified in this page.
They may differ from the actual product.
They may differ from the actual product.
49
KX-TG6521CAB/KX-TG6521CAT/KX-TG6522CAT/KX-TGA651RUB/KX-TGA651RUT
11 Measurements and Adjustments
This chapter explains the measuring equipment, the JIG connection, and the PC setting method necessary for the measurement in
Troubleshooting Guide (P.24)
Troubleshooting Guide (P.24)
11.1. Equipment Required
• Digital multi-meter (DMM): it must be able to measure voltage and current.
• Oscilloscope.
• Frequency counter: It must be precise enough to measure intervals of 1 Hz (precision; ±4 ppm)
• Oscilloscope.
• Frequency counter: It must be precise enough to measure intervals of 1 Hz (precision; ±4 ppm)
Hewlett Packard, 53131A is recommended.
• DECT tester: Rohde & Schwarz, CMD 60 is recommended.
This equipment may be useful in order to precisely adjust like a mass production.
11.2. The Setting Method of JIG (Base Unit)
This section explains the PC setting to use command required in Check Point (Base Unit)(P.36).
<Preparation>
• Serial JIG cable: PQZZ1CD300E*
• PC which runs in DOS mode
• Batch file CD-ROM for setting: PNZZTG6521CA
• PC which runs in DOS mode
• Batch file CD-ROM for setting: PNZZTG6521CA
Note:
*: If you have the JIG Cable for TCD500 series
(PQZZ1CD505E), change the following values of
resistance. Then you can use it as a JIG Cable for both
TCD300 and TCD500 series. (It is an upper compatible JIG
Cable.)
(PQZZ1CD505E), change the following values of
resistance. Then you can use it as a JIG Cable for both
TCD300 and TCD500 series. (It is an upper compatible JIG
Cable.)
11.2.1. Connections
Connect the AC adaptor to DC-JACK (base unit).
Connect the JIG Cable GND (black) to GND.
Connect the JIG Cable RX (red) to URX and TX (yellow) to UTX.
Note:
*: COM port names may vary depending on what your PC calls it.
Resistor
Old value (k
Ω) New value (kΩ)
R2
22
3.3
R3
22
3.3
R4
22
4.7
R7
4.7
10
Click on the first or last page to see other KX-TG6521CAB / KX-TG6521CAT / KX-TG6522CAT / KX-TGA651RUB / KX-TGA651RUT service manuals if exist.