Panasonic KX-TCD450RUM / KX-A145RUM / KX-TCD450RUT / KX-A145RUT Service Manual ▷ View online
6.11. Selecting the Display Language
·
To exit the operation, press
any time.
·
*1 You can select one of 24 languages. If you set a language you cannot read, reset the handset to its initial settings.
Press MENU
→
DOWN
→
RIGHT
→
UP
→
RIGHT
→
4-digit Handset PIN
→
UP
→
OK
All handset setting will be reset to their initial settings, however, the Phonebook data will be saved.
6.12. Select Dialling Mode (Tone/Pulse)
You can change the dialling mode to tone or pulse depending upon your network service. If you have a touch tone service,
select tone. If you have rotary or pulse service, select pulse.
select tone. If you have rotary or pulse service, select pulse.
·
To exit the operation, press
any time.
·
*1: The factory preset is 0000.
6.13. Select Flash Timing
You can select the flash timing, 100 msec (milli seconds), 700 msec, or 200 msec depending on your PBX requirements.
·
To exit the operation, press
any time.
·
*1: The factory preset is 0000.
For Service Hint: Refer to Select Flash Timing (P.17)
17
KX-TCD450RUM / KX-A145RUM / KX-TCD450R UT / KX-A145RUT
6.14. Automatic Route Selection
6.14.1. Relate the Area Code(s) to the Carrier Code(s)
After storing carrier code(s) and area code(s), you must relate the stored area code(s) to your chosen lower costing carrier
code. It is only necessary to relate area codes to carrier codes if more than one carrier code has been stored. If only one carrier
code has been stored, any area codes you store (up to 25) will automatically be dialled with that carrier code.
code. It is only necessary to relate area codes to carrier codes if more than one carrier code has been stored. If only one carrier
code has been stored, any area codes you store (up to 25) will automatically be dialled with that carrier code.
·
To exit the operation, press
any time.
·
*1: The factory preset is 0000.
·
*2 If you need more relating area codes to carrier codes, repeat the steps from 5.
6.14.2. Automatic Route Selection On/Off
·
To exit the operation, press
any time.
·
*1: The factory preset is 0000.
18
KX-TCD450RUM / KX-A145RUM / KX-TCD450R UT / KX-A145RUT
6.15. Summary of Programmable Functions
You can select and execute the following functions by pressing direct command as follows without programming.
These operations need to be done with the Handset near the base unit.
Press
. Press
or
until the arrow points to
, then press
.
is displayed.*1
*1 If any key is not pressed over 60 seconds, the display will return to “Setting Base”.
*2 Refer to PIN Code (P.12) for more details.
19
KX-TCD450RUM / KX-A145RUM / KX-TCD450R UT / KX-A145RUT
7 DISPLAY
7.1. Handset Display
20
KX-TCD450RUM / KX-A145RUM / KX-TCD450R UT / KX-A145RUT
Click on the first or last page to see other KX-TCD450RUM / KX-A145RUM / KX-TCD450RUT / KX-A145RUT service manuals if exist.