Panasonic KX-TCD420RUT / KX-A142RUT Service Manual ▷ View online
9.2. Handset
Shown in Fig.-
To Remove
Remove
3
Rear Cabinet
Screws (2 × 10)..........(B) × 2
4
Rear Cabinet
Follow the procedure.
5
Main P.C. Board
Screw (2 × 8)..............(C ) × 1
Screws (2 × 8).............(D ) × 2
Main P.C. Board
Screws (2 × 8).............(D ) × 2
Main P.C. Board
29
KX-TCD420RUT / KX-A142RUT
9.3. Charger Unit
Shown in Fig.-
To Remove
Remove
6
Lower Cabinet
Screws (2.6 × 14)..........(E) × 2
7
Main P.C. Board
Main P.C. Board
30
KX-TCD420RUT / KX-A142RUT
10 ASSEMBLY INSTRUCTIONS
10.1. Warning When Constructing the Base Unit
CHG terminal is properly fit in the cabinet.
CHG terminal comes out of rib by pulling black lead wire when opening the cabinet and turning
the PCB over. The terminal cannot have enough elastic force, cannot have good contact with
handset, and it will result in charge problem.
the PCB over. The terminal cannot have enough elastic force, cannot have good contact with
handset, and it will result in charge problem.
OK
NG
Rib
31
KX-TCD420RUT / KX-A142RUT
Flow Chart
Cross Reference:
Check Power (P.33)
Bell Reception (P.39)
Check Battery Charge (P.34)
Check Link (P.35)
Check Handset Transmission (P.37)
Check Handset Reception (P.37)
SIGNAL ROUTE (P.61)
TAM Voice Prompt Problems (P.38)
11 TROUBLESHOOTING GUIDE
32
KX-TCD420RUT / KX-A142RUT
Click on the first or last page to see other KX-TCD420RUT / KX-A142RUT service manuals if exist.