Panasonic PT-RZ21KE / PT-RS20K Service Manual ▷ View online
7
PREFACE
< RZ21K / RS20K >
2. Specifications
2. 1 Specifications
The specifications of the projector are as follows.
Power supply
100 V - 120 V / 200 V - 240 V ~ (100 V ‑ 120 V / 200 V ‑ 240 V alternating current), 50 Hz/60 Hz
Power consumption
940 W (9.6 A) / 1 510 W (7.7 A)
Power consumption (during
standby)
When [STANDBY MODE] is set to [ECO]: 0.3 W
When [STANDBY MODE] is set to [NORMAL]: 4 W
When [STANDBY MODE] is set to [NORMAL]: 4 W
DLP chip
Size
PT-RZ21K
24.4 mm (0.96") (aspect ratio 16:10)
PT-RS20K
24.1 mm (0.95") (aspect ratio 4:3)
Display system
DLP chip x 3, DLP projection system
Number of pixels
PT-RZ21K
2 304 000 pixels (1 920 x 1 200 dots)
PT-RS20K
1 470 000 pixels (1 400 x 1 050 dots)
Lens
Optional
Light source
Laser x 2
Light output
20 000 lm
*1 *3
, 21 000 lm (center)
*2 *3
(When [OPERATING MODE] is set to [NORMAL])
Center to corner zone ratio
*1
90 %
Contrast ratio
*1
20 000:1 (when [DYNAMIC CONTRAST] is set to [3])
Color system
7 standards (NTSC/NTSC4.43/PAL/PAL‑N/PAL‑M/SECAM/PAL60)
Projected image size
1.78 m (70") to 25.40 m (1 000")
*4
Image aspect ratio
PT-RZ21K
16:10
PT-RS20K
4:3
Projection method
[FRONT/CEILING], [FRONT/FLOOR], [REAR/CEILING], [REAR/FLOOR]
Power cord length
3.0 m (118‑1/8")
Outer case
Molded plastic
Outer color
Black
Dimensions
Width
598 mm (23‑17/32") (excluding protrusions)
Height
307 mm (12‑3/32") (with the feet at shortest position)
270 mm (10‑5/8") (excluding the feet and protrusion)
270 mm (10‑5/8") (excluding the feet and protrusion)
Depth
725 mm (28‑17/32") (excluding the protrusion)
Weight
Approx. 49.0 k] (108.0 lbs.)
*5
Noise level
*1
46 dB
Operating
environment
Operating
environment
temperature
0 °C (32 °F) to 50 °C (122 °F)
*6*7
Operating
environment
humidity
10 % to 80 % (no condensation)
Remote
control
Power supply
DC 3 V (AA/R6/LR6 battery x 2)
Operating range Within approx. 30 m (98'5") (when operated directly in front of signal receiver)
Weight
Weight
150 ] (5.3 ozs.) (including batteries)
Dimensions
Width: 47.5 mm (1‑7/8"), Height: 181.5 mm (7‑5/32"), Depth: 27.5 mm (1‑3/32")
*1 Measurement, measuring conditions, and method of notation all comply with ISO/IEC 21118:2012 international standards.
*2 The value of the light output at the center region of the projected image is extracted based on the light output measurement method defined by the
ISO/IEC 21118:2012 international standards.
*3 When a projection lens other than ET-D75LE95, ET-D75LE90 is used with the power supply voltage of AC 200 V.
*4 When the Zoom Lens (Model No.: ET‑D75LE8) is used, the projected image size for the maximum projection distance will be 1.78 m (70") to
15.24 m (600"). When the Fixed‑focus Lens (Model No.: ET‑D75LE95, ET‑D75LE90) is used, the projected image size for the maximum projection
distance will be 3.05 m (120") to 15.24 m (600").
*5 Average value. Weight varies for each product.
*6 The operating environment temperature should be between 0 °C (32 °F) and 45 °C (113 °F) if the projector is used at an altitude between 1 400 m
(4 593') and 4 200 m (13 780') above sea level.
*7 When the [PROJECTOR SETUP] menu → [OPERATION SETTING] → [OPERATING MODE] is set to [NORMAL] or [ECO], the light output may be
reduced to protect the projector.
f
When using the projector at an altitude lower than 2 700 m (8 858') above sea level: 35 °C (95 °F)
f
When using the projector at an altitude between 2 700 m (8 858') and 4 200 m (13 780') above sea level: 25 °C (77 °F)
Note
f
The light output will decrease to approximately 1/2 when using the projector with AC 100 V to AC 120 V.
f
The model numbers of accessories and optional accessories are subject to change without prior notice.
8
PREFACE
< RZ21K / RS20K >
2. 2 Terminal
<RGB 1 IN> terminal
1 set (BNC x 5 (RGB/YP
B
P
R
/YC
B
C
R
/YC/VIDEO x 1))
RGB signal
0.7 V [p‑p] 75 Ω (SYNC ON GREEN: 1.0 V [p‑p] 75 Ω)
SYNC/HD
SYNC/HD
TTL high impedance, automatic positive/negative
polarity compatible
VD
TTL high impedance, automatic positive/negative
polarity compatible
YP
B
P
R
signal
Y: 1.0 V [p-p] including synchronization signal, P
B
P
R
: 0.7 V [p‑p] 75 Ω
Y/C signal
Y: 1.0 V [p‑p], C: 0.286 V [p‑p] 75 Ω
VIDEO signal
1.0 V [p‑p] 75 Ω
<RGB 2 IN> terminal
1 set, high‑density D‑Sub 15 p (female)
RGB signal
RGB signal
0.7 V [p‑p] 75 Ω (SYNC ON GREEN: 1.0 V [p‑p] 75 Ω)
SYNC/HD
SYNC/HD
TTL high impedance, automatic positive/negative
polarity compatible
VD
TTL high impedance, automatic positive/negative
polarity compatible
YP
B
P
R
signal
Y: 1.0 V [p-p] including synchronization signal, P
B
P
R
: 0.7 V [p‑p] 75 Ω
<DVI-D IN> terminal
1 set, DVI-D 24 p, single link, DVI 1.0 compliant, HDCP compatible
<HDMI IN> terminal
1 set, HDMI 19 p, HDCP compatible, Deep Color compatible
<SDI IN 1> terminal
1 set (BNC)
Single link SD-SDI
Single link SD-SDI
signal
SMPTE ST 259 compliant
Single link HD-SDI
signal
SMPTE ST 292 compliant
Single link 3G-SDI
signal
SMPTE ST 424, 425-2 compliant
Dual link HD-SDI
signal (Link A signal)
SMPTE ST 372 compliant
Dual link 3G-SDI signal
(Link 1 signal)
SMPTE ST 425-3 compliant
<SDI IN 2> terminal
1 set (BNC)
Single link SD-SDI
Single link SD-SDI
signal
SMPTE ST 259 compliant
Single link HD-SDI
signal
SMPTE ST 292 compliant
Single link 3G-SDI
signal
SMPTE ST 424, 425-2 compliant
Dual link HD-SDI
signal (Link B signal)
SMPTE ST 372 compliant
Dual link 3G-SDI signal
(Link 2 signal)
SMPTE ST 425-3 compliant
<MULTI PROJECTOR SYNC
IN> terminal/<3D SYNC 1 IN/
OUT> terminal (dual purpose)
1 set (BNC)
TTL high impedance
When [3D SYNC MODE] is set to output, TTL output: Maximum 10 mA
TTL high impedance
When [3D SYNC MODE] is set to output, TTL output: Maximum 10 mA
<MULTI PROJECTOR SYNC
OUT> terminal/<3D SYNC 2
OUT> terminal (dual purpose)
1 set (BNC)
TTL output: Maximum 10 mA
<SERIAL IN>/ <SERIAL OUT>
terminal
D-Sub 9 p, 1 set each, RS-232C compliant, for computer control
<REMOTE 1 IN>/ <REMOTE 1
OUT> terminal
M3 stereo mini jack, 1 set each, for remote control (wired)/for projector connection control
<REMOTE 2 IN> terminal
1 set, D-Sub 9 p, for contact control
<DIGITAL LINK/LAN> terminal 1 set, RJ‑45, for network and DIGITAL LINK connections (HDBaseT
TM
compliant), PJLink compatible,
100Base-TX, Art-Net compatible, HDCP compatible, Deep Color compatible
<DC OUT 1> terminal/<DC
OUT 2> terminal
2 sets, USB connector (type A), for power supply only (DC 5 V, 2 A total for two sets)
9
PREFACE
< RZ21K / RS20K >
2. 3 Compatible signal
For details of the types of video signals that can be used with the projector, refer to operating instructions “List of
compatible signals” .
Video signal input, Y/C signal input
Horizontal: 15.73 kHz, Vertical: 59.94 Hz; Horizontal: 15.63 kHz, Vertical: 50 Hz
RGB signal input
Horizontal: 15.73 kHz, Vertical: 59.94 Hz; Horizontal: 15.63 kHz, Vertical: 50 Hz
RGB signal input
f
Resolution: 640 x 400 to 1 920 x 1 200
f
Dot clock frequency: 162 MHz or less
f
PIAS (Panasonic Intelligent Auto Scanning) system
YC
B
C
R
/YP
B
P
R
signal input
f
Resolution: 480i/576i to 1 920 x 1 080
f
Dot clock frequency: 148.5 MHz or less
f
The SYNC/HD and VD terminals do not support 3 value SYNC.
DVI-D signal input
f
Moving image signal resolution: 480i
*1
/576i
*1
to 1 920 x 1 080
Still image signal resolution: 640 x 400 to 1 920 x 1 200 (non‑interlace)
f
Dot clock frequency: 25 MHz to 162 MHz
HDMI signal input
f
Moving image signal resolution: 480i
*1
/576i
*1
to 1 920 x 1 080
Still image signal resolution: 640 x 400 to 1 920 x 1 200 (non‑interlace)
f
Dot clock frequency: 25 MHz to 162 MHz
SDI signal input
SD-SDI signal
HD-SDI signal
3G-SDI signal
SD-SDI signal
HD-SDI signal
3G-SDI signal
*1 Pixel‑Repetition signal (dot clock frequency 27.0 MHz) only
Note
f
DIGITAL LINK input compatible signal is the same as HDMI input compatible signal.
10
PREFACE
< RZ21K / RS20K >
2. 4. Dimensions
Unit: mm
258 (10-5/32")
299 (11-25/32")
598 (23-17/32")
644 (25-11/32")
516 (20-5/16")
142 (5-19/32")
131 (5-5/32")
48 (1-7/8")
270 (10-5/8")
307 (12-3/32")
20 (25/32")
725 (28-17/32")
* Actual dimensions may differ depending on the product.
Click on the first or last page to see other PT-RZ21KE / PT-RS20K service manuals if exist.