Panasonic PT-MZ16K / PT-MZ13K / PT-MZ10K (serv.man2) Service Manual ▷ View online
ADJ-14
SECTION 3 ADJUSTMENTS
<MZ16K/MZ13K/MZ10K>
5. Click [Connection Check] button too check the connection between projector and PC.
• If "Check : OK" is displayed, click the [OK] button and proceed to the next step.
• If "Check : NG" is displayed, check the setting in step 4.
6. Click [load] button on the "Select Microcomputer's firmware file".
7. Select the new firmware, and click [Open] button.
• Display example of LAN connection
• Display example of SERIAL connection
ADJ-15
SECTION 3 ADJUSTMENTS
<MZ16K/MZ13K/MZ10K>
8. After loading the firmware, a checkmark and path name to the firmware and the version will be displayed on the "Version
Information" window.
Click [Update] button to start updating of the firmware if the all information is right
• Uncheck the firmware name if you do not want to update the firmware.
9. Click [OK] button to start updating if the firmware version is right.
During updating, the LED indicators on the projector will light as table below.
ON/STANDBY
LIGHT• TEMP
FILTER
Main
Light in red
Blick in red alternately
Off
Sub
Light in red
DIGITAL LINK
Light in red
LD Driver
Light in green
ADJ-16
SECTION 3 ADJUSTMENTS
<MZ16K/MZ13K/MZ10K>
10. After finishing the updating, the confirmation message is displayed. Click [OK] button.
11. Click [EXIT] button to quit the tool.
After finishing the updating, restart the main power of projector. Enter the service mode and check the version of
each firmware on the sub menu [STATUS] from the main menu [PROJECTOR SETUP].
ADJ-17
SECTION 3 ADJUSTMENTS
<MZ16K/MZ13K/MZ10K>
Click on the first or last page to see other PT-MZ16K / PT-MZ13K / PT-MZ10K (serv.man2) service manuals if exist.