View Panasonic PT-JW130GWE / PT-JW130GBE (serv.man2) Service Manual online
Use lead free solder in servicing from the standpoint of antipollution for the global environment.
For the P.C.Board which applies lead free solder, the symbol as shown in the figure below is printed or stamped on the surface
or the back of P.C.Board.
It dose not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product.
Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any attempt to service
or repair the product or products dealt with in this service information by anyone else could result in serious injury or death.
(Refer to “PROJECTOR SETUP menu” in Operating Instructions.)
Failure to observe this may cause malfunctions. Never use this projector at an altitude of 2,700m or higher.
Using this projector at high altitude, consult your dealer or Authorized Service Center about preparations.
Replace only with the same of equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instructions.
FAISCEAU APPAREIL À LASER
DURÉE DE L'IMPULSION:
RAYONNEMENT DIRECT OU DIFFUS DES YEUX OU DE
diagram. It is essential that these critical parts should be replaced with manufacturer’s specified parts to prevent shock, fire, or other
hazards. Do not modify the original design without permission of Panasonic System Communications Company of North America.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
・Reorient or relocate the receiving antenna.
・Increase the separation between the equipment and receiver.
・Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
・Consult the dealer or an experienced radio/TV technician for help.
2. OSD Menu Navigation
3. Service Mode
4. Control commands via LAN
5. Notification for service operation
2. Disassembly Instructions
2. Software update procedure
2. Interconnection Block Diagram
3. Schematic Diagram
4. Circuit Boards Diagram
2. Replacement Parts List