PT-DZ16KU, PT-DZ16KE, PT-DS16KD (serv.man10) — Panasonic Projector Service Manual (repair manual). Page 3

View Panasonic PT-DZ16KU / PT-DZ16KE / PT-DS16KD (serv.man10) Service Manual online

PREFACE
<PT-DZ16K>
Cautions when transporting
When transporting the projector, remove the projection lens before attaching the dust sponge.
  Otherwise dust will accumulate inside and may cause malfunctions.
When transporting the projector, hold it securely by its bottom and avoid excessive vibration and impacts.
  They may damage the internal components and result in malfunctions.
Do not transport the projector with the adjustable feet extended.
  Doing so may damage the adjustable feet.
Do not set up the projector in the following locations.
The projector is designed for indoor use only.
Places where vibration and impacts occur such as in a car or vehicle: Doing so may cause damage to internal
  components or malfunction.
Near the exhaust of an air conditioner: Depending on the conditions of use, the screen may fluctuate in rare cases
  due to the heated air from the air exhaust port or the hot or cooled air. Make sure that the exhaust from the projector
  or other equipment, or the air from the air conditioner does not blow toward the front of the projector.
Places with sharp temperature fluctuations such as near lights (studio lamps): Doing so may shorten the life
  of the lamp, or result in deformation of the outer case due to heat, which may cause malfunctions.
  The operating environment temperature of the projector should be between 0 °C (32 °F) and 45 °C (113 °F) when
  using it at elevations lower than 1 400 m (4 593') above sea level, and between 0 °C (32 °F) and 40 °C (104 °F) when
  using it at high altitudes (between 1 400 m (4 593') and 2 700 m (8 858') above sea level).
  If you use the Smoke cut filter, the operating environment temperature should be between 0 °C (32 °F) and
  35 °C (95 °F). However, it cannot be used at high altitudes.
Near high-voltage power lines or near motors: Doing so may interfere with the operation of the projector.
Places where there is high-power laser equipment: Directing a laser beam onto the lens surface causes damage
  to the DLP chips.
3
p
Note at the time of installation
The high clarity projection lens is thermally affected by the light from the light source, making the focus unstable in
  
the period just after switching on the power. Wait at least 30 minutes with the image projected before adjusting
  the lens focus.
Make sure to set [HIGH ALTITUDE MODE] to [ON] when using the projector at elevations between 1 400 m (4 593')
  and 2 700 m (8 858') above sea level.
  Do not install the projector at elevations of 2 700 m (8 858') or higher above sea level.
Do not use the projector tilted to the right or left.
Do not install and use the projector in portrait setting.
3
Page of 110
Display

Click on the first or last page to see other PT-DZ16KU / PT-DZ16KE / PT-DS16KD (serv.man10) service manuals if exist.