DOWNLOAD Panasonic DP-2310 / DP-3010 / DP-2330 / DP-3030 (serv.man2) Service Manual ↓ Size: 47.79 MB | Pages: 127 in PDF or view online for FREE

Order Number: MGCS040801C0

H21

This service information is designed for experienced repair technicians only and is not intended for use by the general public.
It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product.
Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any attempt to service 
or repair the product or products dealt within this service information by anyone else could result in serious injury or death.

2

The contents of this Service Manual and the Specifications are 

subject to change 

without notice. 
Panasonic Communications Co., Ltd. reserves the right to make improvements in 
the product design without reservation and without notice.
Published in Japan.

  Information regarding Lead-Free (PbF) solder:

    Distinction of PbF PCB:

PCBs (manufactured) using lead free solder will have a          mark following 
the PCB part numbers in a label on the PCB.

    Caution:

  Pb free solder has a higher melting point than standard solder; typically 
  the melting point is 50 - 70  F (30 - 40  C) higher. Please use a soldering iron 
  with temperature control and adjust it to 700  20  F (370  10  C). Exercise care 
  while using higher temperature soldering irons, do not heat the PCB for too long 
  to prevent solder splash or damage to the PCB.
  Pb free solder will tend to splash when heated too high (about 1100  F/600  C).
  ECO SOLDER M705 (available from Senju Metal Industry Co., Ltd.: 

             URL: 

3

Please read this notice completely BEFORE installing any 

optional accessories. As failure to properly install the additional 

board or connector with the power ON (only the front power 

switch Off) could damage the copier's SPC or SC board.

Please follow the instructions below:

1. It is essential that you turn OFF power to the Main Power 

Switch located in the rear of the copier.

2. It is essential that you unplug the Main AC Power Cord from 

the wall outlet.

3. Please carefully read the installation instructions and follow 

each step.

<Example: DP-2330/3030>

1. Turn the Power Switch on the Left Side of the machine to the OFF position first.
2. Wait approximately 10 seconds while the machine writes the closing status onto the Hard Disk 

Drive Unit.

3. Turn the Main Power Switch on the Back of the machine to the OFF position. 

(This interrupts all the power to the machine)

4. Unplug the AC Power Cord.

* The specifications are subject to change without notice. Panasonic Communications Co., Ltd. reserves 

the right to make improvements in the product design without reservation and without notice.

4

<Beispiel: DP-2330/3030>