DOWNLOAD Panasonic TH-50PB2E Service Manual ↓ Size: 4.61 MB | Pages: 54 in PDF or view online for FREE

16

TH-50PB2E

Picture can be reversed left and right or up and down.
00 : Default (Normal picture is displayed)
01 : Picture is reversed left and right.
02 : Picture is reversed up and down.

Hint : If the defective symptom (e.g. Vertical bar or Horizontal bar) is moved by selection of this mirror, the possible cause is in A-
board.

17

TH-50PB2E

1. Self-check is used to automatically check the bus line

controlled circuit of the Plasma display.

2. To get into the Self-check mode, press the volume down

button on the customer controls at the bottom of the set,
at the same time pressing the OFF-TIMER button on the
remote control, and the screen will show.

If the IIC ports have been checked and found to be incorrect
Or not located then “ - - ” will appear in place of “ OK ”
“ 01 ” in the line of the “ PTCT ” means the number of blinks of
the Power LED is 1. (Reference to 6.1.2)
“ H09 ” in the line of the “ PTCT ” is the error code.

To exit the CAT mode switch off the main power.

The line of the “ PTCT ” displays when you get into the Self-
check mode for the first time only after the Power LED
blinks.

18

TH-50PB2E

1. Subject

Information of LED Blinking timing chart.

2. Contents

When an abnormality has occurred to the unit, the protection circuit operates and resets to the stand by mode. At this time,
the defective block can be identified by the number of blinks of the Power LED on the front panel of the unit.

*

 Refer to 6.1.1 Display Indication

19

TH-50PB2E

First check point
There are following 3 states of No Power indication by power LED.

1. No lit.
2. Green is lit then turns red blinking a few seconds later.
3. Only red is lit.