DOWNLOAD Panasonic TH-42PF30ER Service Manual ↓ Size: 9.31 MB | Pages: 127 in PDF or view online for FREE

29

TH-42PF30ER

6. Remove 2 screws and then remove the Fan Block (A).

7. Disconnect the connectors (DS13, P9).
8. Remove the flexible cable from the connector (DS1).
9. Remove 4 screws and then remove the Slot Block.

10. Disconnect the connector (D25).

11. Remove the flexible cables from the connectors (C11,

C21, D15, SN20).

12. Remove 6 screws and then remove the D-Board.

13. Disconnect the connectors (A11, A13, A16, A22, A37).
14. Remove 2 screws ( ).

15. Remove 2 screws ( ) and then remove the A-Board

Block.

16. Remove 1 screw and then remove the Speaker Terminal

Block.

17. Disconnect the connector (S34).
18. Remove 2 screws and then remove the S1-Board Block.

19. Remove the flexible cables from the connectors (SN21,

SN22, SN23, SN24, SN25, SN26, SN27, SN28).

20. Disconnect the connector (SN2).

30

TH-42PF30ER

21. Remove 8 screws ( ) and then remove SN-Board.

22. Disconnect the connector (SS11).
23. Remove the flexible cables from the connectors (C23,

SS61, SS66).

24. Remove 7 screws and then remove SS-Board.

25. Disconnect the connector (C25).
26. Remove 7 screws and then remove P-Board.

27. Remove the flexible cable from the connectors (C10,

C20).

28. Remove 7 screws and then remove the Handle Fixing

Metal (L, R).

29. Pull the bottom of the Plasma Display Panel forward

(arrow1).

30. Slide the Plasma Display Panel and then remove the

Plasma Display Panel (arrow2).

31. Remove 10 screws and then remove the Hanger Assy (L,

R), the Stand Pole Bracket Assy (L, R) and the Hanger
Fixing Metal Assy (L, R).

31

TH-42PF30ER

32. Exchange the Plasma Display Panel.

32

TH-42PF30ER

When Plasma panel or A-board is replaced, Vsus should be set to LOW or HIGH.

1. Access the CAT mode.

Press and hold the Volume down / - button on the front panel of the unit and press the [RECALL] button on the remote con-
trol 3 times quickly within 2 second, this will place the unit into the CAT mode.

2. Select the IIC mode.
3. Go into item [VSUS] in the IIC mode by Up / Down buttons. LOW or HIGH will be displayed.
4. Press [OK] button to go to TEST stage.

White pattern without On-Screen Display will be displayed during TEST and CONF stage. Press [RECALL] button to display
the On-Screen Display.

5. Press [VOL (-)] button to set to LOW.
6. In LOW setting

a. If no several dead pixel is visible remarkably in white pattern, press [RIGHT] button to go to CONF stage.
b. If the several dead pixels are visible remarkably in white pattern, Set to HIGH by press [VOL (+)] button. Press [RIGHT]

button to go to CONF stage if the symptom is improved.

7. Press [OK] button in CONF stage to store LOW or HIGH.
8. Exit Service Mode by pressing [Power] button.