DOWNLOAD Panasonic KX-TDA1180X (serv.man3) Service Manual ↓ Size: 2.06 MB | Pages: 67 in PDF or view online for FREE

25

• Use only the AC power cord included with the PBX for the PSU.
• Before touching the System Initialise Switch, discharge static electricity by touching ground or wearing an earthing strap.
• Once you have started the PBX and if you unplug the PBX, do not perform the following procedures to start the PBX

again. Otherwise, your programmed data is cleared. To restart the PBX, refer to "Using the Reset Button".

• The power supply cord is used as the main disconnect device. Ensure that the AC outlet is located near the equipment

and is easily accessible.

The PBX will continue to be powered even if the power switch is turned "OFF".

1. Slide the System Initialise Switch to the "INIT" position.

2. Plug the AC power cord into the PBX and an AC outlet, and turn on the PBX. The RUN indicator will flash.

For safety reasons, do not stretch, bend, or pinch the AC power cord.

3. While the RUN indicator is flashing, slide the System Initialise Switch back to the "NORMAL" position. Depending on the con-

figuration, initialisation takes about 1 min to 3 min. If successfully executed, the RUN indicator will stop flashing and stay lit.

All data will be cleared, and the PBX as well as all optional service cards (except for the IP-GW card) will be initialised to the
default values. The DPTs should show the time as 01:00. The data of the IP-GW card will not be initialised.

26

After initialization, program the PBX and connect trunks to the PBX.
To confirm that the trunks are successfully connected, dial [

] [3] [7] + trunk number (3 digits) on a PT, or press the PT’s 

S-CO button. You will hear a dial tone if the trunk is available and connected.

If the PBX does not operate properly, use the Reset Button. Before using the Reset Button, try the system feature again to con-
firm whether there definitely is a problem or not.
Note:

1.When the System Initialise Switch is set to "NORMAL", pressing the Reset Button causes the following:

• Camp-on is cleared.
• Calls on hold are terminated.
• Calls on exclusive hold are terminated.
• Calls in progress are terminated.
• Call park is cleared.

Other data stored in memory, except the above, are not cleared.

2.Be aware that pressing the Reset Button with the System Initialise Switch in the "INIT" position clears all data stored in the

PBX. Do not perform this operation unless you intend to delete all data from the PBX.

1.If the PBX does not operate properly:

a.Slide the System Initialise Switch to the "NORMAL" position.
b.Press the Reset Button for about 1 second

Indication

Color

Description

RUN

Green

PBX status indication
      OFF: Power Off (includes normal reset)
      ON: Power On and running (on-line)
      Flash (60 times per minute): Starting up
      Flash (120 times per minute): Starting up or resetting with:
          the System Initialise Switch in "INIT" position
          the SD Memory Card not inserted

ALARM

Red

Alarm indication
     OFF: Normal
     ON: Alarm (CPU stop, alarm for each optional service card installed in the Basic Shelf)
     Flash: Alarm (MPR file error in restarting)

27

1. Insert the card along the guide rails.

2. Holding the card as shown below, push the release lever in the direction of the arrow so that the card engages securely with

the connector on the back board.

3. Turn the 2 screws clockwise to fix the card in place.

28