DOWNLOAD Panasonic KX-TDA0177XJ / KX-TDA0177X (serv.man2) Service Manual ↓ Size: 3.31 MB | Pages: 74 in PDF or view online for FREE

8

• EC bus interface

Independent bus for 16bit/8MHz two-way address data multiplex.

• CT bus interface

Supports eight 8.192MHz highways (128 time slots).

• Local TSW

Exchanges the time slots between CT bus (1024ch) and local highway (64ch).

• Local highway interface

Accommodates 2.048, 4.096, and 8.192MHz highways (Up to 64 time slots).

• Local gain control

Controls the gain of the local highway up-and-down 64ch in 1db step arbitrarily.

9

• CODEC interface

Can connect up to four Infineon-manufactured PEB2466, and is intended for enabling the line control.

• GPIO interface

Parallel interface that is arbitrarily programmable bidirectionally.

Infineon PEB2466 CODEC is installed. The analogue features such as BN, frequency characteristic, volume level, sidetone are
configured by ASIC CODEC interface DCLK, CS, DOUT, DIN. In addition, the CODEC has an internal I/O port that supports Hook
detection, DTMF detection, BELL relay control and DIAG relay control. Also, it converts A/D to D/A, and 4-line-analogue signal to
PCM code in G.711 format. 

10

It converts 4W-VOX signal used in the PBX to 2W-VOX signal used in SLT, and vice versa. It consists of an operational amplifier in
the HIC and a balanced network in the CODEC. It can control the return loss of the audio data and frequency characteristics. By
modifying the CODEC program, it can match the corresponding impedance. 

Each port has its own DTMF receiver. The receiver detects the signal using IC1 for port A through D, IC2 for port E through H, IC4
for port I through L and IC6 for port M through P. The CODEC detects the DTMF data to be effective at EST terminal=H. This infor-
mation is detected in the MPR via SAMSON, then DTMF signal is detected by MPR reading the DTMF receiver data that came
through the SAMSON local bus.

11

A constant-current power supply in HIC provides +30V, ring side 0V grounding to SLC. The maximum feeding current is 30mA.

When a telephone initiates pulse dialing, this feature detects the pulse-dialing signal.
When the telephone initiates dialing, changes in voltage is detected by the RING terminal in HIC, and this information is transmitted
to the HOOK terminal (Example: 3-pin IC200A) as Make=L/Break=H signal. This digital signal is received by CODEC IC (Example:
35-pin IC201) and recognized as dialing signal. Both 10pps and 20pps can be received. The dialing speed is analyzed by software.