Panasonic KX-HDV130RU / KX-HDV130RUB (serv.man3) Service Manual / Supplement ▷ View online
ORDER NO. KMS1704532SE
SIP Phone
Model No.
KX-HDV130 Series
TABLE OF CONTENTS
PAGE
1 CHANGES----------------------------------------------------------- 2
1.1. Connecting Lead Wires ---------------------------------- 2
1.2. Clamping Lead Wires------------------------------------- 3
1.2. Clamping Lead Wires------------------------------------- 3
Supplement
Model No.
KX-HDV130/B/CB
KX-HDV130A
KX-HDV130A
KX-HDV130NE/NEB
KX-HDV130RU/RUB
KX-HDV130SXB
KX-HDV130X/XB
4
3
3
4
4
4
4
Supplement No.
KMS1505146CE
KMS1510156CE
KMS1508150CE
KMS1502119CE
KMS1506149CE
KMS1505147CE
KMS1503131CE
Service Manual Order No.
Please file and use this supplement manual together with the service manual.
USA, Canada
Czech
Belgium
Europe
Russia, Ukraine, Kazakhstan
India
Asia, Oceania and Middle East
Destinations
2
KX-HDV100 Series
1 CHANGES
1.1.
Connecting Lead Wires
Changed from the Original Service Manual section 10.3.1.
Change of the speaker lead wire length from 18.5 cm to 13 cm.
Blue
Blue
Blue
Purple
Purple
Purple
Purple
Gray
Gray
Gray
Gray
Orange
Orange
Orange
Solder
Solder
Solder
Solder
Solder
Solder
Solder
Solder
Solder
Yellow
Black
Black
Red
Red
Brown
Yellow
Brown
Fully insert the FFC into the
connector until the edge of
the reinforcing plate is
aligned with the edge of the
Main Board.
connector until the edge of
the reinforcing plate is
aligned with the edge of the
Main Board.
Speaker Lead Wire
Cable is to be inserted into connector
(CN504) and (CN101) without any inclining,
as shown.
<NG>
<OK>
Note:
3
KX-HDV100 Series
1.2.
Clamping Lead Wires
Changed from the Original Service Manual section 10.3.2.
Change of the speaker lead wire length from 18.5 cm to 13 cm.
NM
Clamp
Clamp
Clamp
Clamp
Clamp
Clamp
Clamp
1
2
3
4
Clamp LEAD WIRE to each slot as follows.
- No 1 : Wire from Headset Jack (Black & Brown)
- No 2 : Wire from Headset Jack (Red & Yellow)
No clamp LEAD WIRE to each slot as follows and lays at bottom PCB.
- No 3 : Wire from Handset Jack (Black & Brown)
- No 4 : Wire from Handset Jack (Red & Yellow)
- No 1 : Wire from Headset Jack (Black & Brown)
- No 2 : Wire from Headset Jack (Red & Yellow)
No clamp LEAD WIRE to each slot as follows and lays at bottom PCB.
- No 3 : Wire from Handset Jack (Black & Brown)
- No 4 : Wire from Handset Jack (Red & Yellow)
Headset Jack
Handset Jack
Put two Lead Wires in each
Rubber Slit.
Rubber Slit.
Speaker Lead Wire
Display