Panasonic UE-608030 / UE-608031 / UE-608032 Service Manual ▷ View online
10
4.2.2.
Stand Table Unit (UE-608031: available only for installing Stand)
4.2.3.
Short-Throw Arm Unit (UE-608032)
11
4.3.
Assembling the Stand Table Unit (available only for installing Stand)
1. Take the left stand and right stand out of the stand table unit
box, and use the three bolts and collars for each stand to secure
the stands.
• As illustrated, with the bottom of the up/down unit taken out
of the packing box, remove the up/down unit's three bolts and
collars each for the left and for the right.
(Spread cushioning material under the up/down unit to adjust
box, and use the three bolts and collars for each stand to secure
the stands.
• As illustrated, with the bottom of the up/down unit taken out
of the packing box, remove the up/down unit's three bolts and
collars each for the left and for the right.
(Spread cushioning material under the up/down unit to adjust
the height.)
• Loosely secure the left stand and right stand to the up/down
unit using the bolts (8) for securing the left and right stands
provided, the flat washers and spring washers which were
removed, and the collars (9) for securing the left and right
stands.
unit using the bolts (8) for securing the left and right stands
provided, the flat washers and spring washers which were
removed, and the collars (9) for securing the left and right
stands.
Note:
Mount the stands with the sides provided with the
locking casters pointed upward.
locking casters pointed upward.
12
2. Tighten bolts A.
• Use a 6 mm (1/4 in.) allen key to tighten bolts A, and secure the
stand part and the up/down unit.
• Use a 6 mm (1/4 in.) allen key to tighten bolts A, and secure the
stand part and the up/down unit.
13
3. Pull up the pipe part of the stand by hand while tightening bolts
B and C in this order.
B and C in this order.
Note:
Take hold of the pipe part of the stand and, with the
up/down unit pulled up, tighten the bolts.
Take hold of the pipe part of the stand and, with the
up/down unit pulled up, tighten the bolts.
4. Tighten up bolts A, B and C securely.
5. After attaching the left and right stands, place the assembled
parts upright, and check that there is no play either at the front
or back or at the left or right.
parts upright, and check that there is no play either at the front
or back or at the left or right.
• If there is any play in the stand after the assembled parts have
been placed upright, slightly loosen the three bolts each at the
left and right, adjust so that the play in the stand is eliminated,
and then tighten up the bolts again.
6. Secure the table plate between the left and right stands.
• Tip the table as you insert it between both sides of the stand.
Align the table with the position of the bolt holes, and then
tighten the bolts
Align the table with the position of the bolt holes, and then
tighten the bolts
Note:
Securely tighten the bolts (8) for securing the left and right
stands using a force of 5.2 N•m±0.5 N•m (53 kgf•cm ±
5 kgf•cm).
Securely tighten the bolts (8) for securing the left and right
stands using a force of 5.2 N•m±0.5 N•m (53 kgf•cm ±
5 kgf•cm).
Click on the first or last page to see other UE-608030 / UE-608031 / UE-608032 service manuals if exist.