Panasonic UB-5315 / UB-5815 (serv.man2) Service Manual / Supplement ▷ View online
5
3 “SECTION 4 INSTALLATION”
3.1.
“Section 4.4 Installation-1 (Screen Unit, Printer Unit)”
3.1.1.
“Section 4.4.21 Attach the Rear Cover (For Optional Stand Only)”
After peeling off the cover sheets of the adhesive tape, attach the *Rear Cover to the Board Attachments (Upper / Lower) while
matching the top edges of them. Then install the *Rivets.
matching the top edges of them. Then install the *Rivets.
Note: *
Rear Cover and Rivets are included in the optional Stand.
3.2.
“Section 4.8 Assembling the optional Stand”
Note:
All of the contents on this section (4.8) have been deleted. See Service Manual for
UE-608005 / 608005-G instead.
UE-608005 / 608005-G instead.
6
3.3.
“Section 4.9 Adjust Screen Unit Height on the Stand”
This optional Stand has 4 level height locations of the Screen Unit from 1500mm (59.1”) to 2000mm (78.7”) based on the floor.
The following is the procedure how to
The following is the procedure how to
adjust
the height.
1. Loosen the 4 Height Adjustment Handles.
2. Hang the
Step Frame
on the center of the
Reinforcement Pipe
not to lift up the Stand with the Screen Unit.
Note:
Be sure to lift up Board Attachment (Lower), while holding it at the center securely and stepping on the Step
Be sure to lift up Board Attachment (Lower), while holding it at the center securely and stepping on the Step
Frame from the back side after locking casters. Otherwise, it may be difficult to
lift it up and down
smoothly.
7
3. Hang the Screw
(Hexagonal-head bolt)
to the slots in the Slide Plates to adjust the height, convenient for you.
And tighten 4 handles after confirming the screws on the both sides of the Fixing Plates hang in the same height slot.
Note:
The Printer Unit cannot be attached to the Board Attachment (Lower) or detached from
The Printer Unit cannot be attached to the Board Attachment (Lower) or detached from
it
when the Board
Attachment Frame is located at the lowest position. In this case, lift up the frame to slide it to a higher position.
4. Attach the Screw
(M6 x 15)
to prevent the user from adjusting the screen height at the lowest position by mistake.
8
Click on the first or last page to see other UB-5315 / UB-5815 (serv.man2) service manuals if exist.