Panasonic KV-SL1066-M2 / KV-SL1066-U2 / KV-SL1066-B2 / KV-SL1066-K2 / KV-SL1066-C2 / KV-SL1066-CH / KV-SL1056-M2 / KV-SL1056-U2 / KV-SL1055-C2 / KV-SL1055-CH / KV-SL1036-C2 / KV-SL1055-CH / KV-SL1035-C2 / KV-SL1055-CH Service Manual ▷ View online
12
Rear
Security slot
Use a commercially available security cable.
USB connector
USB cable
Connect the USB cable to the scanner and the other end of the USB cable to the computer.
Power cord
Use a commercially available security cable.
USB connector
USB cable
Connect the USB cable to the scanner and the other end of the USB cable to the computer.
Power cord
1
2
3
4
5
AC inlet (M2/U2/B2/K2)
13
4.2.
Operation Panel
1
2
3
5
4
6
7
LED (Red)
Lights when an error occurs.
LED (Green)
Shows the scanner’s status.
Power button ( )
For details, see Operating Manual "Turning ON/OFF the unit's power".
Cursor button
Skip button (
)
If you press this button after a double feed is detected and scanning has been paused, the document (or
documents) detected as a double feed will be scanned, and then ejected from the scanner. Scanning will
continue after the document is scanned and ejected.
documents) detected as a double feed will be scanned, and then ejected from the scanner. Scanning will
continue after the document is scanned and ejected.
Start/Stop button (
)
•
If you set [Wait Key] for "Manual Feed Mode" in your application software, pushing this button starts
scanning. For details about "Manual Feed Mode", refer to the Image Capture Plus, TWAIN, or ISIS
help.
scanning. For details about "Manual Feed Mode", refer to the Image Capture Plus, TWAIN, or ISIS
help.
•
During scanning, pushing this button stops scanning.
•
If you press this button after a double feed is detected and scanning has been paused, the document
(or documents) detected as a double feed will be ejected from the scanner without being scanned.
Scanning will stop.
(or documents) detected as a double feed will be ejected from the scanner without being scanned.
Scanning will stop.
7-segment LED
If you are using the scanner with Image Capture Plus, you can perform a push scan using the 7-
segment LED. A registered job number is displayed on the 7-segment LED. Use the cursor button (
segment LED. A registered job number is displayed on the 7-segment LED. Use the cursor button (
)
to select a job.
14
4.2.1.
About LED
The status of the scanner is displayed by the LED (Red) (
) and the LED (Green) (
), as shown in the
table below:
LED (Red)
LED (Green)
Status
OFF
OFF
Power OFF
*1
OFF
ON
Ready mode or Scanning
OFF
Blinking (Fast)
Warming up
OFF
Blinking (Fast, 2 times consecutively)
Double Feed Skip mode
OFF
Blinking (Fast, 3 times consecutively)
Dog-ear detection skip mode
OFF
Blinking (Slow)
Sleep mode
*2
or Cleaning mode
Blinking (Slow)
Blinking (Slow)
Sleep mode
*2
and Notification mode
Blinking (Slow)
ON
Notification mode
ON
OFF
Error
*3
*1
If the power off feature in sleep mode is enabled, and if no operation is performed for a certain period of time, the scanner will be
turned off automatically. Press the power button (
turned off automatically. Press the power button (
) of the scanner to turn it on. You can enable/disable the power off feature, and
change the time until the scanner turns off in User Utility.
*2
If no operation is performed for 15 minutes or longer, the scanner will enter sleep mode automatically to conserve energy. Press
any button (except the power button) on the scanner’s operation panel to return to ready mode. The time until the scanner enters
sleep mode can be changed in User Utility.
any button (except the power button) on the scanner’s operation panel to return to ready mode. The time until the scanner enters
sleep mode can be changed in User Utility.
*3
For details about the error, check in User Utility.
15
5 Installation Instructions
5.1.
Required Space Around the Scanner
Refer to the concerned pages of Operating Manual (See 16. Appendix (Operating Manual P.12).)
5.2.
Included Accessories
Confirm that the following items are included with this scanner.
Refer to the concerned pages of Operating Manual (See 16. Appendix (Operating Manual P.9).)
Refer to the concerned pages of Operating Manual (See 16. Appendix (Operating Manual P.9).)
5.3.
Installing the Unit
Refer to the concerned pages of Operating Manual (See 16. Appendix (Operating Manual P.13).)
5.4.
Viewing Operating Manual and Help Installed
Refer to the concerned pages of Operating Manual (See 16. Appendix (Operating Manual P.15).)
5.5.
System Requirements
Note
• The above system requirements may not satisfy the requirements of all operating systems.
• The scanning speed differs depending on the host computer's operating environment or the application used.
• Due to the slower speed of USB 1.1, it is recommended to use a USB 2.0 / USB 3.0 / USB 3.1 interface.
• If you connect the scanner to a USB hub, it is not guaranteed to work.
• To use the SharePoint Output with Image Capture Plus, Microsoft.NET Framework 4.5 or later must be installed.
• The scanning speed differs depending on the host computer's operating environment or the application used.
• Due to the slower speed of USB 1.1, it is recommended to use a USB 2.0 / USB 3.0 / USB 3.1 interface.
• If you connect the scanner to a USB hub, it is not guaranteed to work.
• To use the SharePoint Output with Image Capture Plus, Microsoft.NET Framework 4.5 or later must be installed.
Please install Microsoft.NET Framework 4.5 or later.
• To use the SharePoint Online Output with Image Capture Plus, Microsoft.NET Framework 4.0 or later must be installed.
Please install Microsoft.NET Framework 4.0 or later.
• To use the Cloud Output with Image Capture Plus, Microsoft.NET Framework 4. 5 or later must be installed.
Please install Microsoft.NET Framework 4.5 or later.
• To use the SharePoint Online Output with Image Capture Plus, the operating system must be Microsoft Windows 7 or later, or
Microsoft Windows Server2008 R2 or later.
• To use the FTP Output with Image Capture Plus, Microsoft.NET Framework 3.5 must be installed.
Please install Microsoft.NET Framework 3.5 or later.
• To use the Image Capture Plus Express, Microsoft. NET Framework 3.5 must be installed.
Please install Microsoft.NET Framework 3.5 or later.
Trademarks
• Microsoft, Windows, Windows Vista, Windows Server, and Internet Explorer are either registered trademarks or trademarks
of Microsoft Corporation in the United States and/or other countries.
• IBM and AT are trademarks of International Business Machines Corporation in the United States, other countries, or both.
• Intel and Intel Core are trademarks of Intel Corporation in the U.S. and other countries.
• Google
• Intel and Intel Core are trademarks of Intel Corporation in the U.S. and other countries.
®
and Google Chrome
TM
are registered trademarks or trademarks of Google Inc.
• Mozilla
®
and Firefox
®
are registered trademarks of Mozilla Foundation.
• All other trademarks identified herein are the property of their respective owners.
Computer
IBM
®
PC/AT or compatible machine with a CD-ROM drive
CPU
Intel
®
Core
TM
2 Duo 1.8 GHz or higher
Operating System
Microsoft Windows XP operating system SP3 or later
Microsoft Windows Vista operating system SP2 or later
Microsoft Windows 7 operating system
Microsoft Windows 8 operating system
Microsoft Windows 10 operating system
Microsoft Windows Server 2003
Microsoft Windows Server 2008
Microsoft Windows Server 2012
Microsoft Windows Server 2016
Microsoft Windows Vista operating system SP2 or later
Microsoft Windows 7 operating system
Microsoft Windows 8 operating system
Microsoft Windows 10 operating system
Microsoft Windows Server 2003
Microsoft Windows Server 2008
Microsoft Windows Server 2012
Microsoft Windows Server 2016
Recommended Web
browser
browser
Microsoft Internet Explorer
11; Edge
Mozilla
®
Firefox
®
ver.54 or later
Google
®
Chrome™
ver.60 or later
Interface
USB 2.0 / USB 3.0 / USB 3.1
Memory
1 GB or higher
Hard Disk Drive
5 GB or more free space is required.
Click on the first or last page to see other KV-SL1066-M2 / KV-SL1066-U2 / KV-SL1066-B2 / KV-SL1066-K2 / KV-SL1066-C2 / KV-SL1066-CH / KV-SL1056-M2 / KV-SL1056-U2 / KV-SL1055-C2 / KV-SL1055-CH / KV-SL1036-C2 / KV-SL1055-CH / KV-SL1035-C2 / KV-SL1055-CH service manuals if exist.